ASUS RT-G32 rev C1/Serial info
From TechInfoDepot
Jump to navigationJump to searchBoot log with Wive-NG firmware
boot log • >> |
---|
U-Boot 1.1.3 (Mar 28 2011 - 20:31:59) Board: Ralink APSoC DRAM: 32 MB relocate_code Pointer at: 81fb0000 config usb..*** Error: D+/D- is 1/1, config usb failed. ..*** Error: D+/D- is 1/1, config usb failed. Set info->start[0]=BF000000 flash_protect ON: from 0xBF000000 to 0xBF01E5B7 flash_protect ON: from 0xBF030000 to 0xBF030FFF *** Warning - bad CRC, using default environment ============================================ Ralink UBoot Version: 3.4.0.0 -------------------------------------------- ASIC 3052_MP2 (Port5<->None) DRAM component: 256 Mbits SDR DRAM bus: 16 bit Total memory: 32 MBytes Flash component: NOR Flash Date:Mar 28 2011 Time:20:31:59 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ##### The CPU freq = 320 MHZ #### SDRAM bus set to 16 bit SDRAM size =32 Mbytes Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 8: Load Boot Loader code to SDRAM via TFTP. 9: Load Boot Loader code then write to Flash via TFTP. 4 3 2 1 0 3: System Boot system code via Flash. ## Booting image at bf050000 ... Image Name: Wive_WR-150N Created: 2014-12-18 7:27:08 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 3357226 Bytes = 3.2 MB Load Address: 80000000 Entry Point: 8000c410 Verifying Checksum ... OK Uncompressing Kernel Image ... OK No initrd ## Transferring control to Linux (at address 8000c410) ... ## Giving linux memsize in MB, 32 Starting kernel ... Linux version 2.6.21.62 (sfstudio_at_mail.ru@wive-ng.sf.net) (gcc version 4.8.4 20141030 (prerelease) (GCC) #0 Thu Dec 18 13:21:25 OMST 2014 The CPU feqenuce set to 320 MHz LINUX started... The CPU/SYS frequency set to 320/106 MHz CPU revision is: 0001964c (MIPS 24K) DetectRAMsequence MAX memory:[67108864] RAM size detected:[33554432] FullviewRAM:[33554432] Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 ro start_kernel(): bug: interrupts were enabled *very* early, fixing it Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 16kB, 4-way, linesize 32 bytes. Cache parity protection disabled cause = 40808060, status = 11000000 PID hash table entries: 1024 (order: 0, 4096 bytes) calculating r4koff... 0004e200(320000) CPU frequency 320.00 MHz Using 160.000 MHz high precision timer. Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 29896k/32768k available (2017k kernel code, 2872k reserved, 379k data, 104k init, 0k highmem) Mount-cache hash table entries: 512 softirq RT prio: 1. NET: Registered protocol family 16 Time: MIPS clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 512 (order: 0, 4096 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 512 bind 1024) TCP reno registered NET: Registered protocol family 1 ralink flash device: 0x1000000 at 0x1f000000 Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 number of CFI chips: 1 Creating 7 MTD partitions on "Ralink SoC physically mapped flash": 0x00000000-0x00030000 : "Bootloader" 0x00030000-0x00040000 : "Config" 0x00040000-0x00050000 : "Factory" 0x00050000-0x0011fa6a : "Kernel_stub" 0x0011fa6a-0x003d0000 : "RootFS_stub" 0x003d0000-0x00400000 : "RW-FS" 0x00050000-0x003d0000 : "Kernel_RootFS" Load Kernel WDG Timer Module squashfs: version 3.4 (2008/08/26) Phillip Lougher squashfs: LZMA suppport for slax.org by jro io scheduler noop registered (default) Ralink gpio driver initialized Number of GPIO: 52, GPIO mode: 0000039D Ralink APSoC Hardware Watchdog Timer Serial: 8250/16550 driver $Revision: 1.6 $ 2 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0xb0000500 (irq = 37) is a 16550A serial8250: ttyS1 at MMIO 0xb0000c00 (irq = 12) is a 16550A Ralink APSoC Ethernet Driver Initilization. v3.0 256 rx/tx descriptors allocated, mtu = 1500! NAPI enable, weight = 128, Tx Ring = 256, Rx Ring = 256 PROC INIT OK! raeth: disable ESW ports before kernel init. block2mtd: version $Revision: 1.1.1.1 $ Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (4096 buckets, 8192 max) TCP cubic registered ip_tables: (C) 2000-2006 Netfilter Core Team, NET: Registered protocol family 10 ip6_tables: (C) 2000-2006 Netfilter Core Team IPv6 over IPv4 tunneling driver NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> NVRAM: Kernel NVRAM start init. NVRAM: Particion 0 CRC c62705a3 OK. VFS: Mounted root (squashfs filesystem) readonly. mount /proc file system ok! mount /sys file system ok! mount /dev file system ok! mount /var file system ok! Freeing unused kernel memory: 104k freed Build the /dev/console node. Algorithmics/MIPS FPU Emulator v1.5 INIT Touch mdev. INIT Mount /tmp/rootfs INIT Create some persistent nodes in dev. INIT Init RW particion INIT RW File system is ok - preparing... INIT Umount /tmp/rootfs INIT Start init now. ~ # PRECONFIG Preconfigure... PRECONFIG Delete old configs. PRECONFIG Create some folders in var and etc. PRECONFIG Copy web pages to tmpfs. SYSLOG Start klogd SYSLOG Start syslogd local Password for 'Admin' changed Restore time to build time or save time. Thu Dec 18 13:27:00 OMST 2014 Raeth v3.0 (NAPI) phy_tx_ring = 0x0074d000, tx_ring = 0xa074d000 phy_rx_ring0 = 0x0074e000, rx_ring0 = 0xa074e000 GMAC1_MAC_ADRH -- : 0x0000001e GMAC1_MAC_ADRL -- : 0xe3ef9d30 CDMA_CSG_CFG = 81000007 GDMA1_FWD_CFG = 710000 switch reg write offset=e4, value=3f eth2.1: Setting MAC address to eth2.2: Setting MAC address to webs: Listening for HTTP requests at address 192.168.1.1 rm -f /etc/portforward rm -f /etc/macipfilter rm -f /etc/websfilter Content filter disabled. internet.sh Build config for fist WiFi module. 0x1300 = 00064380 0x1300 = 00064380 >>>>> RECONFIGURE WIFI IF = ra0 <<<<<<<<<< >>>>> RECONFIGURE WIFI IF = ra0 <<<<<<<<<< hw_nat: module license 'Proprietary' taints kernel. Ralink HW NAT v2.51.1 Module Enabled, ASIC: RT3350, REV: 0102, FoE Size: 4096 done pppoe_pass: Disabled. ipv6_pass: Disabled [ ! -f /etc/backup/nvram_backup.dat ] && (sleep 20 && fs backup_nvram && fs save) & |