Atel Electronics AT8-4
abg (AG108) | |
---|---|
IEEE 802.11a/g SOHO Access Point | |
WikiDevi.wi-cat.ru | |
3rd Party Firmware | |
dd-wrt | |
OpenWrt |
Incompatible |
Tomato any flavor |
Incompatible |
Platform | |
Brand • Model • Rev |
Atel Electronics AT8-4 |
FCC ID |
none specified |
Type |
access point |
CPU1 |
Atheros AR2312A |
CPU1 Type |
MIPS 4Kc |
CPU1 Speed |
180 MHz |
Flash1 Chip |
Spansion S29JL032H70TFI02 |
Flash1 Size |
4 MiB4,194,304 B <br />32,768 Kib <br />4,096 KiB <br />32 Mib <br />0.00391 GiB <br /> |
RAM1 Size |
16 MiB16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> |
RAM1 Chip |
Micron MT48LC4M32B2-7 G |
ETH chip1 |
Atheros AR2312A |
ETH chip2 |
IC+ IP101 |
Ethernet Port Count |
1-100MbE-LAN |
Wired Standard |
IEEE 802.3i/3u |
Stock FW OS |
Linux 2.4.18-mips |
Expansion IF types |
none specified |
Power |
5 VDC, 2 A |
Connector type |
barrel |
Serial Port (UART) |
yes, internal, 6-pin header, populated, 3.3V TTL, connectorized, (115200 8N1) |
Additional chips | |
Other | |
Default SSID: wlan | |
Manuf/OEM/ODM | |
Retail | |
(Est.) release date | 2005 |
Country of manuf | Taiwan |
Radio 1 | |
Chip1 |
Atheros AR2312A |
Chip2 |
Atheros AR5112A |
Wireless interface OUI |
00:0B:6B |
Antenna Connector Type |
U.FL, RP-SMA |
Wireless Standard |
IEEE 802.11a/b/g |
802.11g |
up to 54 Mbps |
802.11b |
up to 11 Mbps |
802.11a |
up to 54 Mbps |
WiFi Operating Frequency |
2.4 or 5 GHz |
For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented IC+ chipsets with specifications, see IC+.
Overview
"CA804.00A" is silkscreened on the board.
Per the manual, the device is running Linux (kernel ver. 2.4.18).
Links of Interest
JTAG-Serial Info
Serial
Serial Pinouts
JP1 [(GND) (TxD) (...) (RxD) (...) (...)]
boot log |
---|
============================================ AR2312 Boot Loader Interface V1.03e00 2005-10-03 (zImage) ============================================ Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash. 4: Load calibration data then write to Flash via XModem. 0 Total-length = (0x208000) 2129920 bytes, Total-CRC = 0x10bb448e ZImage -CRC = 0x10bb448e Copying image from flash to SDRAM ... flash start= 0xbfc50000; flash end= 0xbfe58000 frequence_setup register_console CPU revision is: 00018009 Primary instruction cache 16kb, linesize 16 bytes (4 ways) Primary data cache 16kb, linesize 16 bytes (4 ways) Linux version 2.4.18-mips (root@localhost.localdomain) (gcc version 2.95.4 20010319 (prerelease)) #2 ▒▒ 9▒▒ 30 10:07:38 CST 2005 Determined physical RAM map: memory: 01000000 @ 00000000 (usable) Initial ramdisk at: 0x80341000 (1633533 bytes) On node 0 totalpages: 4096 zone(0): 4096 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: ip=192.168.1.3:192.168.1.1::netmask::eth0 calculating r4koff... 000dbba0(900000) Calibrating delay loop... 179.81 BogoMIPS Memory: 11108k/16384k available (1122k kernel code, 5276k reserved, 1732k data, 4k init, 0k highmem) Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes) Inode-cache hash table entries: 1024 (order: 1, 8192 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 4096 (order: 2, 16384 bytes) Checking for 'wait' instruction... unavailable. POSIX conformance testing by UNIFIX Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with no serial options enabled ttyS00 at 0xbc000000x (irq = 12) is a 16550A block: 64 slots per queue, batch=16 RAMDISK driver initialized: 16 RAM disks of 6000K size 1024 blocksize loop: loaded (max 8 devices) NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 1024) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Ethernet Bridge 008 for NET4.0 RAMDISK: Compressed image found at block 0 Freeing initrd memory: 1595k freed VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 4k freed Algorithmics/MIPS FPU Emulator v1.5 Bummer, can't write to log on /dev/tty5! console=/dev/ttyS0 init started: BusyBox v0.60.5 (2005.09.06-10:10+0000) multi-call binary Bummer, can't write to log on /dev/tty5! Starting pid 8, console /dev/ttyS0: '/etc/rc.d/rcS' Using /lib/modules/2.4.18-mips/eth.o CA8-4 Eth ver: 2.25e00.2005 Ethernet use flash address Ethernet For CA8-4 ae531x ethMAC(0)= 00:0b:6b:3c:5a:ffffff9c eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: duplex 0, link 1 full 3.19.00 macCtl= 0x1010000c macFlowCtl= 0x00000002 100 sb = 00 0B 6B 3C 5A 9C ether_setup ae531x ethMAC(1)= 00:0b:6b:3c:5a:ffffff9b eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth0: Phy Status=ffff eth1: duplex 0, link 1 full 3.19.00 macCtl= 0x1010000c macFlowCtl= 0x00000002 100 sb = 00 0B 6B 3C 5A 9B ether_setup Using /lib/modules/2.4.18-mips/80211.o Using /lib/modules/2.4.18-mips/oahu.o ar5211.c : Atheros AR5211 driver v0.0 ar5211 hwaddr: 00:0B:6B:3C:5A:9A ar5211 wlan0.11: Device at 0xb8500000, IRQ 5 Using /lib/modules/2.4.18-mips/flashapi.o Bummer, can't write to log on /dev/tty5! Starting pid 18, console /dev/ttyS0: '/bin/sh' BusyBox v0.60.5 (2005.09.30-02:06+0000) Built-in shell (ash) Enter 'help' for a list of built-in commands. # syslogd: Execute for syslog/udp/514 |
cat /proc/version
# cat /proc/version Linux version 2.4.18-mips (root@localhost.localdomain) (gcc version 2.95.4 20010319 (prerelease)) #2 ▒▒ 9▒▒ 30 10:07:38 CST 2005
cat /proc/cpuinfo
# cat /proc/cpuinfo system type : MIPS AR5312 processor : 0 cpu model : MIPS 4Kc V0.9 BogoMIPS : 179.81 wait instruction : no microsecond timers : yes tlb_entries : 16 extra interrupt vector : yes hardware watchpoint : yes VCED exceptions : not available VCEI exceptions : not available
ps aux
# ps aux PID TTY Uid Size State Command 1 0 258516 S init 2 0 0 S [keventd] 3 0 0 S [ksoftirqd_CPU0] 4 0 0 S [kswapd] 5 0 0 S [bdflush] 6 0 0 S [kupdated] 16 0 260488 S CSPX 18 ttyS0 0 258524 S /bin/sh 24 0 258348 S /sbin/syslogd -m 0 41 0 258720 R hostapd -B /etc/hostapd.conf-wlan0 139 0 258484 S thttpd -p 80 -d /var/www/html -c *.cgi -T 157 0 258232 S rebootd 162 0 258260 S /sbin/telnetd -p 23 -l /sbin/CLIX -d 171 0 260488 S CSPX 182 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 183 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 184 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 185 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 186 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 187 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 188 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 189 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 190 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 191 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 192 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 193 0 537852 S upnpd AP lan 80 000b6b3c5a9b AirCA8-4 199 ttyS0 0 258520 R ps aux
- Atel Electronics
- Embedded system/access point
- Embedded System Atheros
- Embedded System AR2312A
- Atheros
- Embedded System MIPS 4Kc
- Embedded System
- Embedded System IP101
- Embedded System IC+
- IC+
- Manuf Wistron NeWeb
- Embedded System AR5112A
- Embedded System IEEE 802.11a/b/g
- Single-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation