BOLT Arion (PL100)
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC1200) | |
|---|---|
| AC1200 LTE Wireless Router | |
|
| |
| 3rd Party Firmware | |
| dd-wrt | Incompatible |
| OpenWrt | Supported |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | BOLT Arion |
| Model Part Number | PL100 |
| FCC ID | none specified |
| Type | wireless router, LTE gateway |
| CPU1 | MediaTek MT7621A |
| CPU1 Type | MIPS 1004Kc |
| CPU1 Speed | 880 MHz ( 2 cores ) 16-bit |
| Flash1 Chip | Brand? Model? |
| Flash1 Size | 32 MiB 33,554,432 B <br />262,144 Kib <br />32,768 KiB <br />256 Mib <br />0.0313 GiB <br /> (SPI NOR) |
| RAM1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (DDR3) |
| RAM1 Chip | Brand? Model? |
| ETH chip1 | MediaTek MT7621A |
| Switch | MediaTek MT7621A |
| Ethernet Port Count |
1-1GbE-WAN 1-1GbE-LAN |
| Wired Standard | IEEE 802.3i/3u/3ab |
|
802dot11 OUI: none specified | |
| Stock bootloader | U-Boot |
| Expansion IF types | none specified |
| Power | 12 VDC, 1.5 A |
| Serial Port (UART) | yes, 3.3V TTL, (57600 8N1) |
|
Flags: | |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Retail | |
| Availability | End of Life |
| End of Life date | 2018 |
| Radio 1 | |
| Chip1 | MediaTek MT7603E |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 300 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | MediaTek MT7612E |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11a/n/ac |
| 802.11ac | up to 867 Mbps |
| 802.11n | up to 300 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
Overview
additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 22.03.0
Current supported version: 24.10.5
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 22.03.0
Current supported version: 24.10.5
LAN Hardware: MediaTek MT7621A
LAN Comment: additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB
WLAN Comment: MediaTek MT7603E, MediaTek MT7612E
Installation method(s):
Telnet, U-Boot TFTP + serial recovery, see git-commit
Recovery method(s):
U-Boot TFTP + serial recovery, see git-commit
Comment:
additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB
LAN Comment: additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB
WLAN Comment: MediaTek MT7603E, MediaTek MT7612E
Installation method(s):
Telnet, U-Boot TFTP + serial recovery, see git-commit
Recovery method(s):
U-Boot TFTP + serial recovery, see git-commit
Comment:
additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB
| git • >> |
|---|
ramips: add support for BOLT! Arion
This device is from now-defunct BOLT! ISP in Indonesia.
The original firmware is based on mediatek SDK running linux 2.6 or 3.x in later revision.
Specifications:
- SoC: MediaTek MT7621
- Flash: 32 MiB NOR SPI
- RAM: 128 MiB DDR3
- Ethernet: 2x 10/100/1000 Mbps (switched, LAN + WAN)
- WIFI0: MT7603E 2.4GHz 802.11b/g/n
- WIFI1: MT7612E 5GHz 802.11ac
- Antennas: 2x internal, non-detachable
- LEDs: Programmable LEDs: 5 blue LEDs (wlan, tel, sig1-3) and 2 red LEDs (wlan and sig1)
Non-programmable "Power" LED
- Buttons: Reset and WPS
Instalation:
Install from TFTP
Set your PC IP to 10.10.10.3 and gateway to 10.10.10.123
Press "1" when turning on the router, and type the initramfs file name
You also need to solder pin header or cable to J4 or neighboring test points (T19-T21)
Pinouts from top to bottom: GND, TX, RX, VCC (3.3v)
Baudrate: 57600n8
There's also an additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB.
Signed-off-by: Abdul Aziz Amar
|
Categories:
- BOLT
- Embedded system/wireless router
- Embedded system/LTE gateway
- Embedded System MediaTek
- Embedded System MT7621A
- MediaTek
- Embedded System MIPS 1004Kc
- Embedded System
- OpenWrt Supported
- Embedded System MT7603E
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System MT7612E
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation