D-Link DAP-3662 rev A1

From TechInfoDepot
Jump to navigationJump to search
abgn+ac (AC1200)
Wireless AC1200 Concurrent Dual-Band Outdoor PoE Access Point
Homepage Product page
Wikipedia D-Link
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Supported
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
Brand • Model • Rev D-Link DAP-3662 rev A1
FCC ID KA2AP3662A1
Type access point
CPU1 checkY Qualcomm Atheros QCA9557
CPU1 Type MIPS 74Kc
CPU1 Speed 775 MHz
Flash1 Chip Brand? Model?
Flash1 Size 16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br />
RAM1 Size 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br />
RAM1 Chip Brand? Model?
ETH chip1 Qualcomm Atheros QCA9557
Switch Qualcomm Atheros QCA8337
Ethernet Port Count 2-1GbE-LAN
Wired Standard IEEE 802.3i/3u/3ab

802dot11 OUI: none specified

Stock bootloader U-Boot
Expansion IF types none specified
PoE 802.3af, standard
Power ? VDC, ? A
Serial Port (UART) yes, 3.3V TTL, (115200 8N1)
Other
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Radio 1
Chip1 Qualcomm Atheros QCA9557
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11b/g/n
802.11n up to 300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz
Radio 2
Chip1 Qualcomm Atheros QCA9882
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11a/n/ac
802.11ac up to 867 Mbps
802.11n up to 300 Mbps
802.11a up to 54 Mbps
WiFi Operating Frequency 5 GHz

For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.

For a list of all currently documented D-Link devices with specifications, see D-Link.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),
• 867 Mbps - 2SS 5GHz 802.11ac (80MHz chan.) = AC1200 class

Flashing

Flashing OpenWrt

Target: ath79
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.2
LAN Comment: Qualcomm Atheros QCA8337
WLAN Comment: Qualcomm Atheros QCA9557, Qualcomm Atheros QCA9882
Installation method(s):
GUI OEM, D-Link Recovery GUI, U-Boot TFTP + serial recovery
Install Comment:
flash factory.img, then flash sysupgrade.bin to reclaim full flash memory
Recovery method(s):
D-Link Recovery GUI, U-Boot TFTP + serial recovery
Recovery Comment:
keep reset button pressed until http upload has started (to prevent reset)
git • >> 
ath79: add support for D-Link DAP-3662 A1
Specifications:
 * QCA9557, 16 MiB Flash, 128 MiB RAM, 802.11n 2T2R
 * QCA9882, 802.11ac 2T2R
 * 2x Gigabit LAN (1x 802.11af PoE)
 * IP68 pole-mountable outdoor case

Installation:
 * Factory Web UI is at 192.168.0.50
   login with 'admin' and blank password, flash factory.bin
 * Recovery Web UI is at 192.168.0.50
   connect network cable, hold reset button during power-on and keep it
   pressed until uploading has started (only required when checksum is ok,
   e.g. for reverting back to oem firmware), flash factory.bin

After flashing factory.bin, additional free space can be reclaimed by
flashing sysupgrade.bin, since the factory image requires some padding
to be accepted for upgrading via OEM Web UI.

Both ethernet ports are set to LAN by default, matching the labelling on
the case. However, since both GMAC Interfaces eth0 and eth1 are connected
to the switch (QCA8337), the user may create an additional 'wan' interface
as desired and override the vlan id settings to map br-lan / wan to either
the PoE or non-PoE port, depending on the individual scenario of use.

So, the LAN and WAN ports would then be connected to different GMACs, e.g.

config interface 'lan'
	option ifname 'eth0.1'
	...

config interface 'wan'
	option ifname 'eth1.2'
	...

config switch_vlan
        option device 'switch0'
        option vlan '1'
        option ports '1 0t'

config switch_vlan
        option device 'switch0'
        option vlan '2'
        option ports '2 6t'

Signed-off-by: Sebastian Schaper
[add configuration example]
Signed-off-by: Adrian Schmutzler
Retrieved from "https://techinfodepot.shoutwiki.com/w/index.php?title=D-Link_DAP-3662_rev_A1&oldid=538769"