Dragino MS12
From TechInfoDepot
Jump to navigationJump to searchbg (G54) | |
---|---|
wireless router | |
3rd Party Firmware | |
dd-wrt |
Status Unknown |
OpenWrt | |
Tomato any flavor |
Incompatible |
Gargoyle |
Status Unknown |
Platform | |
Brand • Model • Rev |
Dragino MS12 |
FCC ID |
none specified |
Type |
wireless router |
CPU1 ![]() | |
CPU1 Type |
MIPS 4KEc |
CPU1 Speed |
180 MHz |
Flash1 Chip |
Brand? Model? |
Flash1 Size |
8 MiB8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> |
RAM1 Size |
16 MiB16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> |
RAM1 Chip |
Brand? Model? |
ETH chip1 | |
Ethernet Port Count |
1-100MbE-LAN |
Wired Standard |
IEEE 802.3i/3u |
802dot11 OUI: none specified | |
Stock bootloader |
RedBoot |
Expansion IF types |
none specified |
Serial Port (UART) |
yes |
JTAG Port |
no |
Other | |
| |
3rd Party Firmware Support | |
Retail | |
Availability | End of Life |
Radio 1 | |
Chip1 | |
Wireless interface OUI |
none specified |
Antenna Connector Type |
none specified |
Wireless Standard |
IEEE 802.11b/g |
802.11g |
up to 54 Mbps |
802.11b |
up to 11 Mbps |
WiFi Operating Frequency |
2.4 GHz |
For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
- • 54 Mbps - 2.4GHz 802.11g = G54 class
Flashing
![]() | NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
![]() | This device is NO LONGER SUPPORTED OR POSSIBLE for future use with OpenWrt. |
On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki
OpenWrt Target: ath25
OpenWrt Subtarget: unknown
OpenWrt Package architecture: mips_4kec
Support started version: 10.03.1
Current supported version: EOL
Last Supported Version: 10.03.1
On the OpenWrt Wiki
OpenWrt Target: ath25
OpenWrt Subtarget: unknown
OpenWrt Package architecture: mips_4kec
Support started version: 10.03.1
Current supported version: EOL
Last Supported Version: 10.03.1
Please insert instructions here