Edimax BR-6475nD
abgn (AN600) | |
---|---|
300Mbps Wireless Concurrent Dual-Band Gigabit iQ Router | |
Homepage | |
WikiDevi.wi-cat.ru | |
3rd Party Firmware | |
dd-wrt |
Status Unknown |
OpenWrt | |
Tomato any flavor |
Incompatible |
Gargoyle |
Status Unknown |
Platform | |
Brand • Model • Rev |
Edimax BR-6475nD rev A |
FCC ID | |
Type |
wireless router |
CPU1 |
Ralink RT3662 |
CPU1 Type |
MIPS 74Kc |
CPU1 Speed |
500 MHz |
Flash1 Chip |
Macronix MX29LV640EBTI-70G |
Flash1 Size |
8 MiB8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> |
RAM1 Size |
64 MiB67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> |
RAM1 Chip |
Winbond W9751G6JB-25 |
ETH chip1 |
Ralink RT3662 |
Switch |
Realtek RTL8367R |
Ethernet Port Count |
1-1GbE-WAN 4-1GbE-LAN |
Wired Standard |
IEEE 802.3i/3u/3ab |
Stock bootloader |
U-Boot |
Expansion IF types |
USB 2.0 (solder pads) |
USB ports |
2 |
USB Hub Compatible |
Untested |
Power |
12 VDC, 1 A |
Connector type |
barrel |
Serial Port (UART) |
yes, (57600 8N1) |
Additional chips | |
Other | |
Default IP address: 192.168.2.1 | |
3rd Party Firmware Support | |
Retail | |
Availability | End of Life |
FCC approval date | 08 June 2011 |
UPC |
649659019607 (UPC DB, On eBay) |
EAN |
4710700927533 (UPC DB, On eBay) |
ASIN | B000Z4J29Q |
Radio 1 | |
Chip1 |
Ralink RT3662 |
Wireless interface OUI |
80:1F:02 |
Antenna Connector Type |
U.FL, RP-SMA |
MIMO status |
2x2:2 |
Wireless Standard |
IEEE 802.11a/n |
802.11n |
up to 300 Mbps |
802.11a |
up to 54 Mbps |
WiFi Operating Frequency |
5 GHz |
Radio 2 | |
Chip1 |
Ralink RT3092 |
Wireless interface OUI |
80:1F:02 |
Antenna Connector Type |
U.FL, RP-SMA |
MIMO status |
2x2:2 |
Wireless Standard |
IEEE 802.11b/g/n |
802.11n |
up to 300 Mbps |
802.11g |
up to 54 Mbps |
802.11b |
up to 11 Mbps |
WiFi Operating Frequency |
2.4 GHz |
For a list of all currently documented Ralink chipsets with specifications, see Ralink.
For a list of all currently documented Realtek chipsets with specifications, see Realtek.
For a list of all currently documented Edimax device with specifications, see Edimax.
Overview
This device supports AP, STA, Bridge, WDS, and universal repeater modes.
"1244-00000737-50Z" is silkscreened on the board in the FCC photos.
FCC docs show two USB ports installed, but this model does not have any populated USB ports.
- Note: The RT3662 SoC only has two native USB 2.0 host IFs
- .. or 1x host and 1x slave/device.
The FCC test report lists the following as identical models
- Edimax BR-6475nD, GR-475nD, EW-7475PDD
- Intellinet 525039
- SMC SMCE21011 V2
- The 2.4GHz radio is using two Microchip (SST) Power Amplifier ICs (SST12LP15A?).
- The 5GHz radio is using two Skyworks (SiGe) SE2537L 5GHz Power Amplifier ICs.
- The third receive chain is unpopulated. There are only two antennas in use.
- Testing of the device on XFastest (CN) (w/ good external and Web UI images)
EDIMAX (2.4 GHz) and EDIMAX2 (5 GHz) SSIDs (probably changed from default?)
- The sample SSIDs shown in the manual are Edimax, 80:1F:02 OUIs
- If not these or EDIMAX+EDIMAX2, the default SSIDs
- may possibly be Edimax2.4GHz and Edimax5GHz.
The power adapter shown in the FCC photos and on XFastest is a
- DVE DSA-12GX-12 FUS 120120 (100-240VAC ~ 50/60Hz, 0.3A -> 12VDC, 1A).
Links of Interest
Edimax's GPL source code for the device (build environment is Fedora 7 i386)
Flashing
NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
This device is NOT RECOMMENDED for future use with OpenWrt due to low flash/ram.
DO NOT BUY DEVICES WITH 8MB FLASH / 64MB RAM if you intend to flash an up-to-date and secure OpenWrt version onto it! See 8/64 warning for details. This device does not have sufficient resources (flash and/or RAM) to provide secure and reliable operation. This means that you will not be able to install many packages, and that you might experience crashes due to OOM situations more or less often. See OpenWrt on 8/64 devices what you can do now. |
On the OpenWrt Wiki
On the OpenWrt Forum
OpenWrt Target: ramips
OpenWrt Subtarget: rt3883
OpenWrt Package architecture: mipsel_74kc
Support started version: 14.07
Current supported version: 23.05.5
Please insert instructions here
JTAG-Serial Info
Serial
Serial Pinouts
To RTL8367R <-- [ (TxD) (GND) (RxD) ][ (Vcc) ] --> To LEDs
Serial Recovery
The serial port is shown as being under the PoE board in the FCC photos.
- It is almost certainly omitted in this particular model.
Pictures
- Edimax
- Embedded system/wireless router
- Embedded System Ralink
- Embedded System RT3662
- Ralink
- Embedded System MIPS 74Kc
- Embedded System
- Embedded System Realtek
- Embedded System RTL8367R
- Realtek
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11a/n
- Embedded System RT3092
- Embedded System IEEE 802.11b/g/n
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation