Fortinet FortiWifi-51E (FWF-51E)

From TechInfoDepot
Jump to navigationJump to search
multiple revisions of this device, use caution
abgn (AN600)
Secure SD-WAN Next Generation Firewall
WikiDevi.wi-cat.ru Fortinet FortiWifi-51E (FWF-51E)
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Supported
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
BrandModelRev Fortinet FortiWifi-51E
Model Part Number FWF-51E
FCC ID TVE-0120201
IC ID 7280B-0120201
Board ID 19K-W13-6900R
Type SD-WAN Firewall
CPU1 checkY Marvell 88F6820
CPU1 Type ARMv7 Cortex-A9
CPU1 Speed 1.6 GHz ( 2 cores )
Flash1 Chip Macronix MX66L1G45GMI-10G
Flash1 Size 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI NOR)
Flash2 Chip A-DATA XM21E
Flash2 Size 32 GiB 32,768 MiB <br />34,359,738,368 B <br />268,435,456 Kib <br />33,554,432 KiB <br />262,144 Mib <br /> (mSATA SSD)
RAM1 Size 2 GiB 2,048 MiB <br />2,147,483,648 B <br />16,777,216 Kib <br />2,097,152 KiB <br />16,384 Mib <br /> (DDR3)
RAM1 Chip Micron MT41K512M8DA-107:P x 4
ETH chip1 Marvell 88F6820
ETH chip2 Marvell 88E1512
ETH chip3 Marvell 88E1512
Switch Marvell 88E6176
Ethernet Port Count 2-1GbE-WAN
5-1GbE-LAN
Wired Standard IEEE 802.3i/3u/3ab

802dot11 OUI: 88:DC:96 (21 E, 22 W)
Ethernet OUI: 90:6C:AC (6 E, -)

Stock bootloader U-Boot
Expansion IF types mSATA, Mini PCIe, USB 3.0
Mini PCIe slots 1
USB ports 1
SATA Ports 1
USB Hub Compatible Untested
Power 12 VDC, 2 A
Connector type Molex (2-pin)
Serial Port (UART) yes, RJ-45 console, (9600 8N1)

Flags:
RTC w/ battery, metal case, heat sink

Additional chips
Low Power 3-5V, 250kbps RS232 Transceiver;Zywyn;ZT3232L;;1;
Hardware Monitoring IC w/ PCI 3.0 Interface;Nuvoton;NCT7802Y;;1;
16-Bit I2C & SMBus I/O Expander w/ Interrupt Output;TI;TCA9555;;1;
4.5-28V, 3A Synchronous Step-Down DC/DC Converter;TI;TPS54336A;;1;
3A Dual Channel Synchronous Step-Down Switcher;TI;TPS54394;;2;
5A Step-Down Regulator w/ Integrated Switcher;TI;TPS53316;;1;
1.8A Sink/Source Bus Termination Regulator;Richtek;RT9045;;1;
3-State Octal Buffer/Line Driver;NXP;LVC244A;;1;

Other

Default SSID: fortinet (3 addl. devices)
Default IP address: 192.168.1.99
the IP 192.168.1.99 is used by 7 additional devices
of which 6 are Fortinet devices
Default login user: admin
Default login password: blank
admin:blank credentials used by 396 additional devices
of which 9 are Fortinet devices

Manuf/OEM/ODM Gemtek WRTM-320N V02
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Retail
Availability End of Life
FCC approval date 06 May 2016
(Est.) release date February 2016
UPC 040232305467
(UPC DB, On eBay)
Country of manuf China
Radio 1
Radio1 module Fortinet EMP7618
Radio1 module IF Mini PCIe (half)
Chip1 Atheros AR9382
Wireless interface OUI 88:DC:96
Antenna Connector Type U.FL, RP-SMA
MIMO status 2x2:2
Wireless Standard IEEE 802.11a/b/g/n
802.11n up to 300/300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
802.11a up to 54 Mbps
WiFi Operating Frequency 2.4 or 5 GHz
 FCC ID
Fortinet EMP7618TVE-0120201
Fortinet FortiWifi-30E (FWF-30E)TVE-0120201
Fortinet FortiWifi-50E (FWF-50E)TVE-0120201
 CPU1 brandRadio1 chip1 brandRadio1 chip2 brand
Fortinet FortiWifi 50E-2R (FWF-50E-2R)MarvellQualcomm Atheros
Fortinet FortiWifi-30E (FWF-30E)MarvellAtheros
Fortinet FortiWifi-50E (FWF-50E)MarvellAtheros
Fortinet FortiWifi-51E (FWF-51E)MarvellAtheros

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Marvell chipsets with specifications, see Marvell.

For a list of all currently documented Fortinet devices with specifications, see Fortinet.

300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),
300 Mbps - 2SS 5GHz 802.11n (40MHz chan.) = AN600 class

Overview

"Model: P17457-03", "FG-51E", "Fortinet, Inc", "19K-W13-6900R RoHs",

and "WRTM-320N_V02" are silkscreened on board.

OEM: Gemtek WRTM-320N (V02)

Hardware specification

Dual-Core ARM (Cortex-A9) @1.6GHz
  • Storage: 128MB SPI (NOR) Flash,
32GB mSATA
  • Memory: 2GB (DDR3) SDRAM
  • Wi-Fi: 802.11abgn Atheros AR9382
  • Network: 7x GbE ports
  • USB: 1x USB 3.0 port
  • Power Source: 12V/3A via 2-pin Molex

Links of Interest

Data Sheet

Flashing

Flashing OpenWrt

Target: mvebu
Subtarget: cortexa9
Package architecture: arm_cortex-a9_vfpv3-d16
Supported Since Commit
Support started version: 24.10.0
Current supported version: 24.10.5
LAN Hardware: Marvell 88E6176
WLAN Hardware: Atheros AR9382 (mini-PCIe)
WLAN Comment: 2x2:2 MIMO
Installation method(s):
see git-commit
Install Comment:
See commit for instructions
Recovery method(s):
see git-commit
git • >>
mvebu: add support for Fortinet FortiWiFi 51E
Fortinet FortiWiFi 51E (FWF-51E) is a UTM with 1x WLAN and 1x SSD, based
on Armada 385 (88F6820).

Specification:

- SoC          : Marvell Armada 385 88F6820
- RAM          : DDR3 2 GiB (4x Micron MT41K512M8DA-107, "D9SGQ")
- Flash        : SPI-NOR 128 MiB (Macronix MX66L1G45GMI-10G)
- SSD          : mSATA SSD 32 GB (A-DATA XM21E (AXM21ES3-32GM-B))
  - mode       : SATA III 6Gbps
  - power      : 3.3 VDC, 3.1 W (Max.)
- Ethernet     : 7x 10/100/1000 Mbps
  - LAN 1-5    : Marvell 88E6176
  - WAN 1, 2   : Marvell 88E1512 (2x)
- WLAN         : Fortinet EMP7618-FT (Atheros AR9382 (2T2R))
  - interface  : MiniPCIe
- LEDs/Keys    : 18x/1x
- UART         : "CONSOLE" port (RJ-45, RS-232C level)
  - port       : ttyS0
  - settings   : 9600bps 8n1
  - assignment : 1:NC , 2:NC , 3:TXD, 4:GND,
                 5:GND, 6:RXD, 7:NC , 8:NC
  - note       : compatible with Cisco console cable
- HW Monitoring: nuvoTon NCT7802Y
- Power        : 12 VDC, 2 A
  - plug       : Molex 5557-02R

Flash instruction using initramfs image:

 1. Power on FWF-51E and interrupt to show bootmenu
 2. Call "[I]: System information." -> "[S]: Set serial port baudrate."
    and set baudrate to 9600 bps
 3. Call "[R]: Review TFTP parameters.", check TFTP parameters and
    connect computer to "Image download port" in the parameters
 4. Prepare TFTP server with the parameters obtained above
 5. Rename OpenWrt initramfs image to "image.out" and put to TFTP
    directory
 6. Call "[T]: Initiate TFTP firmware transfer." to download initramfs
    image from TFTP server
 7. Type "R" key when the following message is showed, to boot initramfs
    image without flashing to spi-nor flash

    "Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]?"

 8. On initramfs image, backup mtd if needed

    minimum:

    - "firmware-info"
    - "kernel"
    - "rootfs"

 9. On initramfs image, upload sysupgrade image to the device and perform
    sysupgrade
10. Wait ~200 seconds to complete flashing and rebooting.
    If the device is booted with stock firmware, login to bootmenu and
    call "[B]: Boot with backup firmware and set as default." to set the
    first OS image as default and boot it.

Notes:

- Both colors of Bi-color LEDs on the front panel cannot be turned on at
  the same time.

- "PWR" and "Logo" LEDs are connected to power source directly.

- The following partitions are added for OpenWrt.
  These partitions are contained in "uboot" partition (0x0-0x1fffff) on
  stock firmware.

  - "firmware-info"
  - "dtb"
  - "u-boot-env"
  - "board-info"

Image header for bootmenu tftp:

  0x0 - 0xf  : ?
 0x10 - 0x2f : Image Name
 0x30 - 0x17f: ?
0x180 - 0x183: Kernel Offset*
0x184 - 0x187: Kernel Length*
0x188 - 0x18b: RootFS Offset (ext2)*
0x18c - 0x18f: RootFS Length (ext2)*
0x190 - 0x193: DTB Offset
0x194 - 0x197: DTB Length
0x198 - 0x19b: Data Offset (jffs2)
0x19c - 0x19f: Data Length (jffs2)
0x1a0 - 0x1ff: ?

*: required for initramfs image

MAC addresses:

(eth0): 90:6C:AC:xx:xx:98 (board-info (OpenWrt), 0xd880 (hex))
WAN 1 : 90:6C:AC:xx:xx:99
WAN 2 : 90:6C:AC:xx:xx:9A
LAN 1 : 90:6C:AC:xx:xx:9B
LAN 2 : 90:6C:AC:xx:xx:9C
LAN 3 : 90:6C:AC:xx:xx:9D
LAN 4 : 90:6C:AC:xx:xx:9E
LAN 5 : 90:6C:AC:xx:xx:9F
WLAN  : 88:DC:96:xx:xx:xx (MiniPCIe Card)

Pictures

User Images