Fortinet FortiWifi 50E-2R (FWF-50E-2R)

From TechInfoDepot
Jump to navigationJump to search
multiple revisions of this device, use caution
abgn+ac (AC1200)
Secure SD-WAN Next Generation Firewall
WikiDevi.wi-cat.ru Fortinet FortiWifi 50E-2R (FWF-50E-2R)
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Supported
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
Brand • Model • Rev Fortinet FortiWifi-50E-2R (FWF-50E-2R)
FCC ID TVE-120506
IC ID 7208B-120506
Board ID 19K-514-6000R
Type SD-WAN Firewall
CPU1 checkY Marvell 88F6820
CPU1 Type ARMv7 Cortex-A9
CPU1 Speed 1.6 GHz ( 2 cores )
Flash1 Chip Macronix MX66L1G45GMI-10G
Flash1 Size 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI NOR)
RAM1 Size 2 GiB 2,048 MiB <br />2,147,483,648 B <br />16,777,216 Kib <br />2,097,152 KiB <br />16,384 Mib <br /> (DDR3 SDRAM)
RAM1 Chip Nanya NT5CC512M8EN-EK x 4
ETH chip1 Brand? Model?
ETH chip2 Marvell 88E1512
ETH chip3 Marvell 88E1512
Switch Marvell 88E6176
Ethernet Port Count 2-1GbE-WAN
5-1GbE-LAN
Wired Standard IEEE 802.3i/3u/3ab

802dot11 OUI: 1C:49:7B (1 E, 3 W)
Ethernet OUI: 70:4C:A5 (3 E, -), 90:6C:AC (6 E, -)

Stock bootloader U-Boot
Expansion IF types Mini PCIe, USB 3.0
Mini PCIe slots 2
USB ports 1
USB Hub Compatible Untested
Power 12 VDC, 2.5 A
Connector type Molex (2-pin)
Serial Port (UART) yes, RJ-45 console, (9600 8N1)

Flags:
RTC w/ battery, metal case, heat sink

Additional chips
Low Power 3-5V, 250kbps RS232 Transceiver;Zywyn;ZT3232L;;1;
Hardware Monitoring IC w/ PCI 3.0 Interface;Nuvoton;NCT7802Y;;1;
16-Bit I2C & SMBus I/O Expander w/ Interrupt Output;TI;TCA9555;;1;
4.5-28V, 3A Synchronous Step-Down DC/DC Converter;TI;TPS54336A;;1;
3A Dual Channel Synchronous Step-Down Switcher;TI;TPS54394;;2;
5A Step-Down Regulator w/ Integrated Switcher;TI;TPS53316;;1;
1.8A Sink/Source Bus Termination Regulator;Richtek;RT9045;;1;
3-State Octal Buffer/Line Driver;NXP;LVC244A;;1;

Other

Default SSID: fortinet (3 addl. devices)
Default IP address: 192.168.1.99
the IP 192.168.1.99 is used by 7 additional devices
of which 6 are Fortinet devices
Default login user: admin
Default login password: blank
admin:blank credentials used by 396 additional devices
of which 9 are Fortinet devices

Manuf/OEM/ODM Gemtek WRTM-319N
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Retail
Availability End of Life
FCC approval date 10 September 2015
Country of manuf China
Radio 1
Radio1 module Gemtek WMDQ-177ACN
Radio1 module IF Mini PCIe
Chip1 Qualcomm Atheros QCA9892
Wireless interface OUI 1C:49:7B
Antenna Connector Type U.FL, RP-SMA
MIMO status 2x2:2
Wireless Standard IEEE 802.11b/g/n
802.11n up to 300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz
Radio 2
Radio2 module Gemtek WMDQ-177ACN
Radio2 module IF Mini PCIe
Chip1 Qualcomm Atheros QCA9892
Wireless interface OUI 1C:49:7B
Antenna Connector Type U.FL, RP-SMA
MIMO status 2x2:2
Wireless Standard IEEE 802.11a/n/ac
802.11ac up to 867 Mbps
802.11n up to 300 Mbps
802.11a up to 54 Mbps
WiFi Operating Frequency 5 GHz
 FCC ID
Gemtek WMDQ-177ACNTVE-120506
 CPU1 brandRadio1 chip1 brandRadio2 chip1 brand
Fortinet FortiWifi 50E-2R (FWF-50E-2R)MarvellQualcomm AtherosQualcomm Atheros
Fortinet FortiWifi-30E (FWF-30E)MarvellAtheros
Fortinet FortiWifi-50E (FWF-50E)MarvellAtheros
Fortinet FortiWifi-51E (FWF-51E)MarvellAtheros

For a list of all currently documented Marvell chipsets with specifications, see Marvell.
For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.

For a list of all currently documented Fortinet devices with specifications, see Fortinet.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),
• 867 Mbps - 2SS 5GHz 802.11ac (80MHz chan.) = AC1200 class

Overview

"Model: P17457-04", "FG-51E", "Fortinet, Inc", "19K-514-6000R RoHs",

and "WRTM-319N_214US_DR_V01" are silkscreened on board.

OEM: Gemtek WRTM-319N

Hardware specification

Dual-Core ARM (Cortex-A9) @1.6GHz
  • Storage: 128MB SPI (NOR) Flash,
  • Memory: 2GB (DDR3) SDRAM
  • Wi-Fi: 2x 802.11abgn/ac Qualcomm Atheros QCA9892
  • Network: 7x GbE ports
  • USB: 1x USB 3.0 port
  • Power Source: 12V/3A via 2-pin Molex

Links of Interest

Flashing

Flashing OpenWrt

Target: mvebu
Subtarget: cortexa9
Package architecture: arm_cortex-a9_vfpv3-d16
Supported Since Commit
Support started version: 24.10.0
Current supported version: 24.10.5
LAN Hardware: Marvell 88E6176
WLAN Hardware: 2x Qualcomm Atheros QCA9892 (mini-PCIe)
WLAN Comment: MIMO 2x2:2 on both bands
Installation method(s):
see git-commit
Install Comment:
See commit for instructions
Recovery method(s):
see git-commit
git • >> 
mvebu: add support for Fortinet FortiWiFi 50E-2R
Fortinet FortiWiFi 50E-2R (FWF-50E-2R) is a UTM with 2x WLAN, based on
Armada 385 (88F6820).

Specification:

- SoC          : Marvell Armada 385 88F6820
- RAM          : DDR3 2 GiB (4x Nanya NT5CC512M8EN-EK)
- Flash        : SPI-NOR 128 MiB (Macronix MX66L1G45GMI-10G)
- Ethernet     : 7x 10/100/1000 Mbps
  - LAN 1-5    : Marvell 88E6176
  - WAN 1, 2   : Marvell 88E1512 (2x)
- WLAN         : Gemtek WMDQ-177ACN (Qualcomm Atheros QCA9892 (2T2R))
                 (2x)
  - interface  : MiniPCIe
- LEDs/Keys    : 18x/1x
- UART         : "CONSOLE" port (RJ-45, RS-232C level)
  - port       : ttyS0
  - settings   : 9600bps 8n1
  - assignment : 1:NC , 2:NC , 3:TXD, 4:GND,
                 5:GND, 6:RXD, 7:NC , 8:NC
  - note       : compatible with Cisco console cable
- HW Monitoring: nuvoTon NCT7802Y
- Power        : 12 VDC, 2.5 A
  - plug       : Molex 5557-02R

Flash instruction using initramfs image:

 1. Power on FWF-50E-2R and interrupt to show bootmenu
 2. Call "[I]: System information." -> "[S]: Set serial port baudrate."
    and set baudrate to 9600 bps
 3. Call "[R]: Review TFTP parameters.", check TFTP parameters and
    connect computer to "Image download port" in the parameters
 4. Prepare TFTP server with the parameters obtained above
 5. Rename OpenWrt initramfs image to "image.out" and put to TFTP
    directory
 6. Call "[T]: Initiate TFTP firmware transfer." to download initramfs
    image from TFTP server
 7. Type "R" key when the following message is showed, to boot initramfs
    image without flashing to spi-nor flash

    "Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]?"

 8. On initramfs image, backup mtd if needed

    minimum:

    - "firmware-info"
    - "kernel"
    - "rootfs"

 9. On initramfs image, upload sysupgrade image to the device and perform
    sysupgrade
10. Wait ~200 seconds to complete flashing and rebooting.
    If the device is booted with stock firmware, login to bootmenu and
    call "[B]: Boot with backup firmware and set as default." to set the
    first OS image as default and boot it.

Notes:

- Both colors of Bi-color LEDs on the front panel cannot be turned on at
  the same time.

- "PWR" and "Logo" LEDs are connected to power source directly.

- The following partitions are added for OpenWrt.
  These partitions are contained in "uboot" partition (0x0-0x1fffff) on
  stock firmware.

  - "firmware-info"
  - "dtb"
  - "u-boot-env"
  - "board-info"

Image header for bootmenu tftp:

  0x0 - 0xf  : ?
 0x10 - 0x2f : Image Name
 0x30 - 0x17f: ?
0x180 - 0x183: Kernel Offset*
0x184 - 0x187: Kernel Length*
0x188 - 0x18b: RootFS Offset (ext2)*
0x18c - 0x18f: RootFS Length (ext2)*
0x190 - 0x193: DTB Offset
0x194 - 0x197: DTB Length
0x198 - 0x19b: Data Offset (jffs2)
0x19c - 0x19f: Data Length (jffs2)
0x1a0 - 0x1ff: ?

*: required for initramfs image

MAC addresses:

(eth0): 90:6C:AC:xx:xx:98 (board-info (OpenWrt), 0xd880 (hex))
WAN 1 : 90:6C:AC:xx:xx:99
WAN 2 : 90:6C:AC:xx:xx:9A
LAN 1 : 90:6C:AC:xx:xx:9B
LAN 2 : 90:6C:AC:xx:xx:9C
LAN 3 : 90:6C:AC:xx:xx:9D
LAN 4 : 90:6C:AC:xx:xx:9E
LAN 5 : 90:6C:AC:xx:xx:9F
WLAN 1: 1C:49:7B:xx:xx:xx (MiniPCIe Card)
WLAN 2: 1C:49:7B:xx:xx:xx (MiniPCIe Card)

Pictures

User Images
  • Board Top
    Board Top
  • Board Bottom
    Board Bottom
Retrieved from "https://techinfodepot.shoutwiki.com/w/index.php?title=Fortinet_FortiWifi_50E-2R_(FWF-50E-2R)&oldid=525115"