HiWiFi HC5962

abgn+ac (AC1200)
AC1200 Wireless Router
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	HiWiFi HC5962
FCC ID	none specified
Type	wireless router
CPU1 Y	MediaTek MT7621AT
CPU1 Type	MIPS 1004Kc
CPU1 Speed	880 MHz ( 2 cores ) 16-bit
Flash1 Chip	Brand? Model?
Flash1 Size	128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (NAND)
RAM1 Size	256 MiB 268,435,456 B <br />2,097,152 Kib <br />262,144 KiB <br />2,048 Mib <br />0.25 GiB <br />
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7621AT
Switch	MediaTek MT7621AT
Ethernet Port Count	4-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	USB 2.0, USB 3.0
USB ports	2
USB Hub Compatible	Untested
Serial Port (UART)	yes
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Retail
Availability	End of Life
Radio 1
Chip1	MediaTek MT7603EN
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7612EN
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 867 Mbps
802.11n	up to 300 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),

• 867 Mbps - 2SS 5GHz 802.11ac (80MHz chan.) = AC1200 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)

Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 18.06.0
Current supported version: 25.12.3

LAN Hardware: MediaTek MT7621AT
WLAN Hardware: MediaTek MT7603EN, MediaTek MT7612EN
Installation method(s):
see git-commit

git • >>

ramips: add support for HiWiFi HC5962 This patch adds supports for the HiWiFi HC5962(gee4) http://www.hiwifi.com Short specification: - MT7621AT + MT7612EN + 7603EN - 256MB DDR3 RAM - 128MB NAND flash - 1+3 x 1000M Ethernet - 1x USB 2.0 port. 1x USB 3.0 port. - reset button - UART pad on PCB (JP3: TX, RX, GND, 3.3V) Flash instruction: 1, Download lede-ramips-mt7621-hc5962-squashfs-factory.bin 2, Login as root via SSH on 192.168.199.1 and then copy factory.bin(using wget or nc or...) to /tmp/ 3, use the following commands: $ mtd write /tmp/lede-ramips-mt7621-hc5962-squashfs-factory.bin firmware $ mtd erase firmware_backup && reboot After reboot you should be able to login as root via SSH on 192.168.1.1 Signed-off-by: ZengFei Zhang