Keenetic Starter (KN-1111)

From TechInfoDepot
Jump to navigationJump to search
multiple revisions of this device, use caution
bgn (N300)
N300 Whole Home Wi-Fi Router
Keenetic Starter (KN-1111).png
Homepage
Wikipedia
WikiDevi.wi-cat.ru
3rd Party Firmware
dd-wrt
Status Unknown
OpenWrt
Status Unknown
Tomato any flavor
Incompatible
Platform
Brand • Model • Rev
ZyXEL Keenetic Starter
Model Part Number
KN-1111
FCC ID
none specified
Board ID
2050501433
Type
wireless router
CPU1
CPU1 Type
MIPS 24KEc
CPU1 Speed
575 MHz
Flash1 Chip
Winbond W25Q256JVFQ
Flash1 Size
16 MiB16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br />
RAM1 Size
64 MiB67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br />
RAM1 Chip
ESMT M14D5121632A
ETH chip1
Switch
Ethernet Port Count
1-100MbE-WAN
3-100MbE-LAN
Wired Standard
IEEE 802.3i/3u

802dot11 OUI: 50:FF:20 (5 E, 5 W)
Ethernet OUI: 50:FF:20 (5 E, 5 W)

Stock FW OS
Linux
Expansion IF types
none specified
Power
9 VDC, 0.6 A
Connector type
barrel
Serial Port (UART)
yes, 4-pin header, (115200 8N1)
Other

Default IP address: 192.168.1.1
the IP 192.168.1.1 is used by 1324 additional devices
of which 96 are ZyXEL devices
Default login user: admin
Default login password: blank
admin:blank credentials used by 366 additional devices
of which 9 are ZyXEL devices

Manuf/OEM/ODM
Retail
Availability Russia only?
Country of manuf China
Radio 1
Chip1
Wireless interface OUI
50:FF:20
Antenna Connector Type
none specified
MIMO status
2x2:2
Wireless Standard
IEEE 802.11b/g/n
802.11n
up to 300 Mbps
802.11g
up to 54 Mbps
802.11b
up to 11 Mbps
WiFi Operating Frequency
2.4 GHz
 CPU1 brandRadio1 chip1 brandRadio1 chip2 brand
Keenetic Start (KN-1110)MediaTekMediaTek
Keenetic Starter (KN-1111)MediaTekMediaTek

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented ZyXEL device with specifications, see ZyXEL.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.) = N300 class

Overview

  • Keenetic Start (KN-1110)
  • Keenetic Start (KN-1111)
See also: ZyXEL/Keenetic series

Links of Interest

Reviews

JTAG-Serial Info

Serial

Bootlog (KN-1111_stable_3.03.C.12.0-0 version firmware 2020-02-28) • >> 
U-Boot 1.1.3 [4.0.0.4-10] (Nov 22 2017 - 08:09:11)

Board: Ralink APSoC DRAM:  64 MB
relocate_code Pointer at: 83fb0000


******************************
Software System Reset Occurred
******************************
MediaTek SPI BBU flash driver, SPI clock: 32MHz
flash manufacture id: c2, device id 20 19
find flash: MX25L25635E
*** Warning - bad CRC, using default environment

============================================
Ralink UBoot Version: 4.0.0.4_NDMS
--------------------------------------------
ASIC 7628_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date:Nov 22 2017  Time:08:09:11
============================================
icache: sets:512, ways:4, linesz:32, total:65536
dcache: sets:256, ways:4, linesz:32, total:32768

 ##### The CPU freq = 580 MHZ ####
 estimate memory size = 64 Mbytes

Resetting MT7628 PHY...
Dual image:     on
Boot active:    1
Boot backup:    1
Boot fails:     0


Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Enter boot command line interface.
   7: Load Boot Loader code then write to Flash via Serial.
   9: Load Boot Loader code then write to Flash via TFTP.                                                                                 0

3: System Boot system code via Flash.
## Booting image at bc050000 ...
   Image Name:   KN-1111
   Created:      2020-02-28   5:53:00 UTC
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    1318491 Bytes =  1.3 MB
   Load Address: 80000000
   Entry Point:  802f8f84
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 802f8f84) ...
## Giving linux memsize in MB, 64

Starting kernel ...


LINUX started...
Linux version version 4.9-ndm-4 (developers@ndmsystems.com) (gcc version 8.3.0 (crosstool-NG 1.24.0-rc2-ndm-7 - NDMS Toolkit 1.0.0) ) #2 Thu Feb 20 20:33:17 MSK 2020
MediaTek SoC: MT7628A, RevID: 0102, RAM: DDR2, XTAL: 40MHz
CPU/OCP/SYS frequency: 580/193/193 MHz
SoC power status: Hard reset occured
CPU0 revision is: 00019655 (MIPS 24KEc)
Determined physical RAM map:
 memory: 04000000 @ 00000000 (usable)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Zone ranges:
  Normal   [mem 0x0000000000000000-0x0000000003ffffff]
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x0000000000000000-0x0000000003ffffff]
Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: console=ttyS0,115200n8
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Writing ErrCtl register=00030d40
Readback ErrCtl register=00030d40
Memory: 60856K/65536K available (3036K kernel code, 124K rwdata, 572K rodata, 196K init, 83K bss, 4680K reserved, 0K cma-reserved)
NR_IRQS:40
Setting up vectored interrupts
clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns
sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns
console [ttyS0] enabled
Calibrating delay loop... 385.02 BogoMIPS (lpj=770048)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 7645041785100000 ns
futex hash table entries: 256 (order: -1, 3072 bytes)
NET: Registered protocol family 16
clocksource: Switched to clocksource MIPS
NET: Registered protocol family 2
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
Load Ralink WDG Timer Module
workingset: timestamp_bits=29 max_order=14 bucket_order=0
squashfs: version 4.0 (2009/01/31) Phillip Lougher
io scheduler noop registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000c00 (irq = 28, base_baud = 2500000) is a 16550A
Registering NDM partitions parser
MediaTek BBU SPI flash driver, SPI clock: 32MHz
SPI flash chip: MX25L25635F (c2 2019c220) (32768 Kbytes)
di: active = 1, backup = 1, current = 1
14 ndmpart partitions found on MTD device raspi
Creating 14 MTD partitions on "raspi":
0x000000000000-0x000000030000 : "U-Boot"
0x000000030000-0x000000040000 : "U-Config"
0x000000040000-0x000000050000 : "RF-EEPROM"
0x000000050000-0x0000001b0000 : "Kernel_1"
0x0000001b0000-0x000000fb0000 : "RootFS_1"
mtd: device 4 (RootFS_1) set to be root filesystem
0x000000050000-0x000000fb0000 : "Firmware_1"
0x000000fb0000-0x000000ff0000 : "Config_1"
0x000000ff0000-0x000001000000 : "Dump"
0x000001000000-0x000001030000 : "U-State"
0x000001030000-0x000001040000 : "U-Config_res"
0x000001040000-0x000001050000 : "RF-EEPROM_res"
0x000001050000-0x000001fb0000 : "Firmware_2"
0x000001fb0000-0x000001ff0000 : "Config_2"
0x000000000000-0x000002000000 : "Full"
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
PPP generic driver version 2.4.2
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPTP driver version 0.8.5
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (8192 buckets, 32768 max)
ctnetlink v0.93: registering with nfnetlink.
Fast NAT loaded
ip_set: protocol 6
ipip: IPv4 and MPLS over IPv4 tunneling driver
gre: GRE over IPv4 demultiplexor driver
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
ubridge: Tiny bridge driver, 1.2
8021q: 802.1Q VLAN Support v1.8
VFS: Mounted root (squashfs filesystem) readonly on device 31:4.
Freeing unused kernel memory: 196K
This architecture does not have kernel memory protection.
RNG reseed started
random: crng init done
RNG reseeded
init: init process was started.
init: press Enter to activate this console.
[I] Jan  1 00:00:03 ndm: Core::Main: ***
[I] Jan  1 00:00:03 ndm: Core::Main: *** Network Device Manager 3.03.C.12.0-0.
[I] Jan  1 00:00:03 ndm: Core::Main: *** Built Feb 20 2020 20:26:16.
[I] Jan  1 00:00:03 ndm: Core::Main: ***
[I] Jan  1 00:00:04 ndm: Core::System::Mtd::Table: current firmware image index is 1.
[I] Jan  1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/nf_nat_proto_gre.ko.
[I] Jan  1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/crypto_null.ko.
[I] Jan  1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/udp_tunnel.ko.
[I] Jan  1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/ip_gre.ko.

Pictures

User Images

  • Keenetic Start (KN-1110) pcb

See also

Keenetic Start/Starter Models

Retrieved from "https://techinfodepot.shoutwiki.com/w/index.php?title=Keenetic_Starter_(KN-1111)&oldid=404717"