Linksys EA7450

abgn+ac (AC1900)
Max-Stream AC1900 MU-MIMO Gigabit Dual-Band Wi-Fi Router
Support	Support page
Wikipedia	Linksys routers
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Linksys EA7450
FCC ID	Q87-03397
Type	wireless router
CPU1 Y	MediaTek MT7621AT
CPU1 Type	MIPS 1004Kc
CPU1 Speed	880 MHz ( 2 cores ) 16-bit
Flash1 Chip	Winbond W29N01HVSINA
Flash1 Size	128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (NAND)
RAM1 Size	256 MiB268,435,456 B <br />2,097,152 Kib <br />262,144 KiB <br />2,048 Mib <br />0.25 GiB <br /> (DDR3 -1600)
RAM1 Chip	Winbond W632GG6MB-12
ETH chip1	MediaTek MT7621AT
Switch	MediaTek MT7621AT
Ethernet Port Count	1-1GbE-WAN 4-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	USB 3.0
USB ports	1
USB Hub Compatible	Untested
Power	12 VDC, 2 A
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Retail
UPC	745883784301 (UPC DB, On eBay)
ASIN	B0851MCPWK
Radio 1
Chip1	MediaTek MT7603E
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7615N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x4:4
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 1733 Mbps
802.11n	up to 600 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz
FCC ID Linksys EA7300 v2 Q87-03397

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented Linksys devices with specifications, see Linksys.

• 600 Mbps - 3SS 2.4GHz 802.11n (40MHz chan., 256-QAM),

• 1300 Mbps - 3SS 5GHz 802.11ac (80MHz chan.) = AC1900 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki

Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 25.12.0
Current supported version: 25.12.5

LAN Hardware: MediaTek MT7621AT
WLAN Hardware: MediaTek MT7603E, MediaTek MT7615N
WLAN Comment: MIMO 2x2:2 2.4Ghz, MIMO 4x4:4 5Ghz
Installation method(s):
GUI OEM
Recovery method(s):
see git-commit

git • >>

ramips: add support for Linksys EA7300 v2 This submission relied heavily on the work of Santiago Rodriguez-Papa <contact at rodsan.dev> Specifications: * SoC: MediaTek MT7621A (880 MHz 2c/4t) * RAM: Winbond W632GG6MB-12 (256M DDR3-1600) * Flash: Winbond W29N01HVSINA (128M NAND) * Eth: MediaTek MT7621A (10/100/1000 Mbps x5) * Radio: MT7603E/MT7615N (2.4 GHz & 5 GHz) 4 antennae: 1 internal and 3 non-deatachable * USB: 3.0 (x1) * LEDs: White (x1 logo) Green (x6 eth + wps) Orange (x5, hardware-bound) * Buttons: Reset (x1) WPS (x1) Installation: Flash factory image through GUI. This might fail due to the A/B nature of this device. When flashing, OEM firmware writes over the non-booted partition. If booted from 'A', flashing over 'B' won't work. To get around this, you should flash the OEM image over itself. This will then boot the router from 'B' and allow you to flash OpenWRT without problems. Reverting to factory firmware: Hard-reset the router three times to force it to boot from 'B.' This is where the stock firmware resides. To remove any traces of OpenWRT from your router simply flash the OEM image at this point. Signed-off-by: J. Scott Heppler