Linksys RE7000
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC2100) | |||||
|---|---|---|---|---|---|
| Max-Stream AC1900+ MU-MIMO Wi-Fi Range Extender | |||||
|
| |||||
| Support | Support page | ||||
| Wikipedia | Linksys routers | ||||
| WikiDevi.wi-cat.ru | Linksys RE7000 | ||||
| 3rd Party Firmware | |||||
| dd-wrt | Status Unknown | ||||
| OpenWrt | Supported | ||||
| Tomato any flavor | Incompatible | ||||
| Gargoyle | Status Unknown | ||||
| Platform | |||||
| Brand • Model • Rev | Linksys RE7000 | ||||
| FCC ID | Q87-RE7000 | ||||
| IC ID | 3839A-RE7000 | ||||
| Board ID | 0500-2540800400 | ||||
| Type | range extender | ||||
| CPU1 | MediaTek MT7621AT | ||||
| CPU1 Type | MIPS 1004Kc | ||||
| CPU1 Speed | 880 MHz ( 2 cores ) 16-bit | ||||
| Flash1 Chip | Macronix MX25L12835FM2I-10G | ||||
| Flash1 Size | 16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> | ||||
| RAM1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> | ||||
| RAM1 Chip | Nanya NT5CC64M16GP-DI | ||||
| ETH chip1 | MediaTek MT7621AT | ||||
| Ethernet Port Count | 1-1GbE-LAN | ||||
| Wired Standard | IEEE 802.3i/3u/3ab | ||||
|
802dot11 OUI: none specified | |||||
| Stock bootloader | U-Boot | ||||
| Expansion IF types | none specified | ||||
| Power | 100-240 VAC ~ 50/60 Hz, 0.5 A | ||||
| Connector type | NEMA 1-15P | ||||
| Serial Port (UART) | yes, 4-pin header, 3.3V TTL, (57600 8N1) | ||||
|
Flags: | |||||
|
| |||||
| Other | |||||
|
| |||||
| Manuf/OEM/ODM | U-MEDIA | ||||
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) | ||||
| Retail | |||||
| FCC approval date | 14 April 2016 | ||||
| (Est.) release date | 25 May 2016 | ||||
| (Est.) initial retail price (in USD): | $149.99 | ||||
| ASIN |
B01DT48WZS | ||||
| Country of manuf | Taiwan | ||||
| Radio 1 | |||||
| Chip1 | MediaTek MT7603EN | ||||
| Wireless interface OUI | none specified | ||||
| Antenna Connector Type | U.FL | ||||
| MIMO status | 2x2:2 | ||||
| Wireless Standard | IEEE 802.11b/g/n | ||||
| 802.11n | up to 300 Mbps | ||||
| 802.11g | up to 54 Mbps | ||||
| 802.11b | up to 11 Mbps | ||||
| WiFi Operating Frequency | 2.4 GHz | ||||
| Radio 2 | |||||
| Chip1 | MediaTek MT7615N | ||||
| Wireless interface OUI | none specified | ||||
| Antenna Connector Type | U.FL | ||||
| MIMO status | 4x4:4 | ||||
| Wireless Standard | IEEE 802.11a/n/ac | ||||
| 802.11ac | up to 1733 Mbps | ||||
| 802.11n | up to 600 Mbps | ||||
| 802.11a | up to 54 Mbps | ||||
| WiFi Operating Frequency | 5 GHz | ||||
| |||||
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
For a list of all currently documented Linksys devices with specifications, see Linksys.
Overview
- FCC ID: Q87-RE7000 (2016-04-14) AC1733/N300
- FCC ID: Q87-RE6800 (2016-12-15) AC1733/N300
- Antenna: 4x internal PCB (2x 2.4/5GHz, 2x 5GHz)
"0500-2540800400" and "1602" (01/2016) is silkscreened on the board.
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 23.05.0
Current supported version: fix
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 23.05.0
Current supported version: fix
WLAN Hardware: MediaTek MT7603EN, MediaTek MT7615N
WLAN Comment: MIMO 2x2:2 for each band
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
WLAN Comment: MIMO 2x2:2 for each band
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
| git • >> |
|---|
ramips: add support for Linksys RE7000 Hardware specification: - SoC: MediaTek MT7621AT (880 MHz) - Flash: 16 MB (Macronix MX25L12835FM2I-10G) - RAM: 128 MB (Nanya NT5CC64M16GP-DI) - WLAN 2.4 GHz: 2x2 MediaTek MT7603EN - WLAN 5 GHz: 2x2 MediaTek MT7615N - Ethernet: 1x 10/100/1000 Mbps - LED: Power, Wifi, WPS - Button: Reset, WPS - UART: 1:VCC, 2:GND, 3:TX, 4:RX (from LAN port) Serial console @ 57600,8n1 Flash instructions: Connect to serial console and start up the device. As the bootloader got locked you need to type in a password to unlock U-Boot access. When you see the following output on the console: relocate_code Pointer at: 87f1c000 type in the super secure password: 1234567890 Then select TFTP boot from RAM by selecting option 1 in the boot menu. As Linksys decided to leave out a basic TFTP configuration you need to set server- & client ip as well as the image filename the device will search for. You need to use the initramfs openwrt image for the TFTP boot process. Once openwrt has booted up, upload the sysupgrade image via scp and run sysupgrade as normal. |
See also
- Linksys RE6300 - AC750 BOOST Wi-Fi Range Extender
- • FCC ID: Q87-RE6300 (2015-09-17) • PPage
- Linksys RE6400 - AC1200 BOOST EX Wi-Fi Range Extender
- • FCC ID: Q87-RE6400 (2015-09-21) • PPage
- Linksys RE6500 - AC1200 Dual-Band Wireless Range Extender
- • FCC ID: Q87-RE6500 (2014-04-24) AC1200 MAX WiFi • PPage
- Linksys RE6500HG - AC1200 Dual-Band Wireless Range Extender
- High-Gain antennas AMPLIFY Wi-Fi signal • PPage
- Linksys RE6700 - AC1200 AMPLIFY Dual-Band Wi-Fi Range Extender
- • FCC ID: Q87-RE6700 (2015-04-17) Wireless Extender •
- Linksys RE6800 - AC1900 Dual-Band Wireless Range Extender
- • FCC ID: Q87-RE6800 (2016-12-15) • (ex-RE7000)
- Linksys RE7000 - Max-Stream AC1900+ MU-MIMO Wi-Fi Range Extender
- • FCC ID: Q87-RE7000 (2016-04-14) AC1733/N300 • PPage
Categories:
- Linksys
- Embedded system/range extender
- Embedded System MediaTek
- Embedded System MT7621AT
- MediaTek
- Embedded System MIPS 1004Kc
- Embedded System
- Manuf U-MEDIA
- OpenWrt Supported
- Embedded System MT7603EN
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System MT7615N
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation