MikroTik RouterBOARD SXTsq 5 ac (RBSXTsqG-5acD)

an+ac (AC867)
Low-cost small-size 16dBi 5GHz dual chain integrated CPE
Homepage	Product page
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	MikroTik RouterBOARD SXTsq 5 ac
Model Part Number	RBSXTsqG-5acD
FCC ID	none specified
Type	access point, CPE
CPU1 Y	Qualcomm Atheros IPQ4018
CPU1 Type	ARMv7 Cortex-A7
CPU1 Speed	716 MHz ( 4 cores )
Flash1 Chip	Brand? Model?
Flash1 Size	16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br />
RAM1 Size	256 MiB 268,435,456 B <br />2,097,152 Kib <br />262,144 KiB <br />2,048 Mib <br />0.25 GiB <br />
RAM1 Chip	Brand? Model?
ETH chip1	Qualcomm Atheros IPQ4018
Ethernet Port Count	1-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: none specified
Stock bootloader	RouterBOOT
Expansion IF types	none specified
PoE	Passive
Power	? VDC, ? A
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Radio 1
Chip1	Qualcomm Atheros IPQ4018
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 867 Mbps
802.11n	up to 300 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz

For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.

For a list of all currently documented MikroTik devices with specifications, see MikroTik.

• 867 Mbps - 2SS 5GHz 802.11ac (80MHz chan.) = AC867 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki

Target: ipq40xx
Subtarget: mikrotik
Package architecture: arm_cortex-a7_neon-vfpv4
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.5

WLAN Hardware: Qualcomm Atheros IPQ4018
Installation method(s):
Mikrotik TFTP, see git-commit

git • >>

ipq40xx: add support for MikroTik SXTsq 5 ac This commit adds support for the MikroTik SXTsq 5 ac (RBSXTsqG-5acD), an outdoor 802.11ac wireless CPE with one 10/100/1000 Mbps Ethernet port. Specifications: - SoC: Qualcomm Atheros IPQ4018 - RAM: 256 MB - Storage: 16 MB NOR - Wireless: IPQ4018 (SoC) 802.11a/n/ac 2x2:2, 16 dBi antennae - Ethernet: IPQ4018 (SoC) 1x 10/100/1000 port, 10-28 Vdc PoE in - 1x Ethernet LED (green) - 7x user-controllable LEDs · 1x power (blue) · 1x user (green) · 5x rssi (green) Note: Serial UART is probably available on the board, but it has not been tested. Flashing: Boot via TFTP the initramfs image. Then, upload a sysupgrade image via SSH and flash it normally. More info at the "Common procedures for MikroTik products" page https://openwrt.org/toh/mikrotik/common.