NEC Aterm WG2600HP2

multiple revisions of this device, use caution

abgn+ac (AC2400)
AC2400 Wireless Router
Homepage	Product page
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	NEC WG2600HP2
FCC ID	none specified
Type	wireless router
CPU1 Y	Qualcomm Atheros IPQ8065
CPU1 Type	ARMv7-A
CPU1 Speed	1.4 GHz ( 2 cores )
Flash1 Chip	Cypress S25FL256S
Flash1 Size	32 MiB 33,554,432 B <br />262,144 Kib <br />32,768 KiB <br />256 Mib <br />0.0313 GiB <br /> (SPI NOR)
RAM1 Size	512 MiB 536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br />
RAM1 Chip	Brand? Model?
ETH chip1	Qualcomm Atheros IPQ8065
Switch	Atheros AR8337
Ethernet Port Count	1-1GbE-WAN 4-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	USB 3.0
USB ports	1
USB Hub Compatible	Untested
Power	12 VDC, 1.5 A
Connector type	barrel
Serial Port (UART)	yes, UART 3.3V, (115200 8N1)
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Retail
Availability	End of Life
End of Life date	2018
Radio 1
Chip1	Qualcomm Atheros QCA9984
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x4:4
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 600 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	Qualcomm Atheros QCA9984
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x4:4
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 1733 Mbps
802.11n	up to 600 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz
CPU1 brand Radio1 chip1 brand Radio2 chip1 brand NEC Aterm WG2600HP Qualcomm Qualcomm Atheros Qualcomm Atheros NEC Aterm WG2600HP2 Qualcomm Atheros Qualcomm Atheros Qualcomm Atheros NEC Aterm WG2600HP3 Qualcomm Qualcomm Atheros Qualcomm Atheros

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.

For a list of all currently documented NEC devices with specifications, see NEC.

• 600 Mbps - 4SS 2.4GHz 802.11n (40MHz chan.),

• 1733 Mbps - 4SS 5GHz 802.11ac (80MHz chan.) = AC2400 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)

Target: ipq806x
Subtarget: generic
Package architecture: arm_cortex-a15_neon-vfpv4
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.6

LAN Hardware: Atheros AR8337
WLAN Hardware: 2x Qualcomm Atheros QCA9984
Installation method(s):
TFTP generic

git • >>

ipq806x: add support for NEC Platforms Aterm WG2600HP3 NEC Platforms Aterm WG2600HP3 is a dual-band router based on Qualcomm IPQ8062. Specification ------------- - SoC: Qualcomm IPQ8062 - RAM: 512MiB - Flash memory: SPI-NOR 32MiB (Cypress S25FL256S) - Wi-Fi: Qualcomm QCA9984 (2.4GHz, 1ch - 13ch) - Wi-Fi: Qualcomm QCA9984 (5GHz, 36ch - 64ch, 100ch - 140ch) - Ethernet: 4x 100/1000 Mbps (1x WAN, 4x LAN) - LED: 6x green LED, 6x red LED - Input: 2x tactile switch, 1x SP3T slide switch - Serial console: 115200bps, through-hole J3 - [ ] [GND] [ ] [TX] [RX] ----> DC jack - Power: DC 12V 1.5A This device does not support VHT160 and VHT80+80. Custom BDFs are required to limit VHT capabilities. Flash instructions ------------------ 1. Setup TFTP server (IP address: 192.168.1.2) 2. Put initramfs image into TFTP server directory 3. Connect WG2600HP3 lan port and computer that runs TFTP server 4. Connect to the serial console 5. Interrupt booting by Esc key (password: chiron) 6. Execute the following commands # setenv bootcmd "nboot 0x44000000 1 0x860000" # saveenv # setenv ipaddr 192.168.1.1 # setenv serverip 192.168.1.2 # tftpboot 0x44000000 openwrt-ipq806x-generic-nec_wg2600hp3-initramfs-uImage 7. After booting OpenWrt initramfs image, backup SPI-NOR flash memory 8. Erase firmware partition # mtd erase firmware 9. Run sysupgrade