NanoPi M1 Plus
From TechInfoDepot
Jump to navigationJump to search
| bgn (N150) | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Single Board Computer | |||||||||||||
|
| |||||||||||||
| Homepage | Product page | ||||||||||||
| Support | Support page | ||||||||||||
| 3rd Party Firmware | |||||||||||||
| dd-wrt | Status Unknown | ||||||||||||
| OpenWrt | Partial Support | ||||||||||||
| Tomato any flavor | Incompatible | ||||||||||||
| Gargoyle | Status Unknown | ||||||||||||
| Platform | |||||||||||||
| Brand • Model • Rev | FriendlyELEC NanoPi M1 Plus | ||||||||||||
| FCC ID | none specified | ||||||||||||
| Type | single-board computer | ||||||||||||
| CPU1 | Allwinner H3 | ||||||||||||
| CPU1 Type | ARMv7-A Cortex-A7 | ||||||||||||
| CPU1 Speed | 1.2 GHz ( 4 cores ) | ||||||||||||
| Flash1 Chip | Brand? Model? | ||||||||||||
| Flash1 Size | 8 GiB 8,192 MiB <br />8,589,934,592 B <br />67,108,864 Kib <br />8,388,608 KiB <br />65,536 Mib <br /> (eMMC) | ||||||||||||
| RAM1 Size | 1 GiB 1,024 MiB <br />1,073,741,824 B <br />8,388,608 Kib <br />1,048,576 KiB <br />8,192 Mib <br /> (DDR3) | ||||||||||||
| RAM1 Chip | Brand? Model? | ||||||||||||
| ETH chip1 | Allwinner H3 | ||||||||||||
| ETH chip2 | Realtek RTL8211E | ||||||||||||
| Ethernet Port Count | 1-1GbE-LAN | ||||||||||||
| Wired Standard | IEEE 802.3i/3u/3ab | ||||||||||||
|
802dot11 OUI: none specified | |||||||||||||
| Stock bootloader | U-Boot | ||||||||||||
| Expansion IF types | eMMC, USB 2.0, HDMI, microSD | ||||||||||||
| USB ports | 2 | ||||||||||||
| SD/MMC Slots | 1 | ||||||||||||
| HDMI | 1 | ||||||||||||
| USB Hub Compatible | Untested | ||||||||||||
| Power | 5 VDC, 2 A | ||||||||||||
| Connector type | USB Female (Micro-B) | ||||||||||||
| Serial Port (UART) | yes, 3.3V TTL, (115200 8N1) | ||||||||||||
|
| |||||||||||||
|
| |||||||||||||
| Other | |||||||||||||
|
| |||||||||||||
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) | ||||||||||||
| Radio 1 | |||||||||||||
| Radio1 module | AMPAK AP6212A | ||||||||||||
| Radio1 module IF | unknown | ||||||||||||
| Chip1 | Broadcom BCM43430 | ||||||||||||
| Wireless interface OUI | none specified | ||||||||||||
| Antenna Connector Type | none specified | ||||||||||||
| MIMO status | 1x1:1 | ||||||||||||
| Wireless Standard | IEEE 802.11b/g/n | ||||||||||||
| 802.11n | up to 150 Mbps | ||||||||||||
| 802.11g | up to 54 Mbps | ||||||||||||
| 802.11b | up to 11 Mbps | ||||||||||||
| WiFi Operating Frequency | 2.4 GHz | ||||||||||||
| |||||||||||||
For a list of all currently documented Allwinner SoC's with specifications, see Allwinner.
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
For a list of all currently documented Realtek chipsets with specifications, see Realtek.
For a list of all currently documented FriendlyELEC devices with specifications, see FriendlyELEC.
- • 150 Mbps - 1SS 2.4GHz 802.11n (40MHz chan.) = N150 class
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
| Devices with Broadcom WiFi chipsets have limited OpenWrt supportability (due to limited FLOSS driver availability for Broadcom chips). Consider this when choosing a device to buy, or when deciding to flash OpenWrt on your device because it is listed as supported. See Broadcom WiFi for details. |
Target: sunxi
Subtarget: cortexa7
Package architecture: arm_cortex-a7_neon-vfpv4
Supported Since Commit
Support started version: 18.06.0
Current supported version: 25.12.1
Subtarget: cortexa7
Package architecture: arm_cortex-a7_neon-vfpv4
Supported Since Commit
Support started version: 18.06.0
Current supported version: 25.12.1
Unsupported Functions:
Bluetooth
LAN Comment: Realtek RTL8211E GbE Phy
WLAN Hardware: AMPAK AP6212A (Broadcom BCM43430)
WLAN Comment: Bluetooth also via AMPAK AP6212A
Installation method(s):
CF card, Sunxi installation
Recovery method(s):
SD card, unknown
Bluetooth
LAN Comment: Realtek RTL8211E GbE Phy
WLAN Hardware: AMPAK AP6212A (Broadcom BCM43430)
WLAN Comment: Bluetooth also via AMPAK AP6212A
Installation method(s):
CF card, Sunxi installation
Recovery method(s):
SD card, unknown
| git • >> |
|---|
sunxi: add support for NanoPi M1 Plus board Backported devicetree from Kernel 4.13 with some additions to enable Ethernet and WiFi module The following features are working: - Ethernet - WiFi - eMMC and microSD slot - USB ports The following features are not working: * Bluetooth NanoPi M1 Plus key features - SoC: Allwinner H3, Quad-core Cortex-A7@1.2GHz - RAM: 1GB DDR3 - eMMC: 8GB - microSD slot - Ethernet 10/100/1000M - Wifi: AP6212 |
Categories:
- FriendlyELEC
- Embedded system/single-board computer
- Embedded System Allwinner
- Embedded System H3
- Allwinner
- Embedded System ARMv7-A
- Embedded System Cortex-A7
- Embedded System RTL8211E
- Embedded System Realtek
- Realtek
- OpenWrt Supported
- Embedded System Broadcom
- Embedded System BCM43430
- Broadcom
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Single-Radio Wireless Embedded System
- Wireless Embedded System
- Single-Band
- Embedded System
- English Documentation