Netcraze NAP-630

abgn+ac+ax (AX3000)
Netcraze Orbiter 6
Homepage	Product page
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Netcraze NAP-630
FCC ID	none specified
Type	access point
CPU1 Y	MediaTek MT7981B
CPU1 Type	ARM Cortex-A53
CPU1 Speed	1.3 GHz ( 2 cores ) 64-bit
Flash1 Chip	Brand? Model?
Flash1 Size	128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI NAND)
RAM1 Size	512 MiB536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br />
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7981B
ETH chip2	Airoha EN8811H
Ethernet Port Count	1-2.5GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab/3bz
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	none specified
PoE	802.3at, standard
Power	? VDC, ? A
Serial Port (UART)	yes, 3.3V TTL, (115200 8N1)
Flags: Wi-Fi 6
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Radio 1
Chip1	MediaTek MT7981B
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n/ax
802.11ax	up to 574 Mbps
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7981B
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/n/ac/ax
AX-QAM	up to 2402 Mbps
802.11ax	up to 1201 Mbps
802.11ac	up to 867 Mbps
802.11n	up to 300 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz

For a list of all currently documented Airoha (EcoNet) chipsets with specifications, see Airoha.
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

• 574 Mbps - 2SS 2.4GHz 802.11ax (40MHz chan., 1024QAM),

• 2402 Mbps - 2SS 5GHz 802.11ax (160MHz chan., 1024QAM) = AX3000 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)

Target: mediatek
Subtarget: filogic
Package architecture: aarch64_cortex-a53
Supported Since Commit
Support started version: unknown
Current supported version: snapshot

LAN Hardware: Airoha EN8811H phy
WLAN Hardware: MediaTek MT7981B
Installation method(s):
see git-commit
Recovery method(s):
see git-commit

git • >>

mediatek: add support for Keenetic/Netcraze (K/N)AP-630 This commit adds support for Keenetic/Netcraze (K/N)AP-630 Specification: - MT7981 CPU using 2.4GHz and 5GHz WiFi (both AX) - 512MB RAM - 128MB SPI NAND - 1 led with two colors (green, orange) - 1 button (reset) - 1 2.5Gbit POE ethernet port based on Airoha EN8811H phy Serial Interface: - 3 Pins GND, RX, TX - Settings: 115200, 8N1 Notes: - The device supports dual boot mode Flash instruction: The only way to flash OpenWrt image is to use tftp recovery mode in U-Boot: 1. Configure PC with static IP 192.168.1.2/24 and tftp server. 2. Copy image to tftp server. a) Keenetic Rename "openwrt-mediatek-filogic-keenetic_kap-630-squashfs-factory.bin" to "KAP-630_recovery.bin" and place it in tftp server directory. b) Netcraze Rename "openwrt-mediatek-filogic-netcraze_nap-630-squashfs-factory.bin" to "NAP-630_recovery.bin" and place it in tftp server directory. 3. Connect PC with ethernet port, press the reset button, power up the device and keep button pressed until status led start blinking. 4. Device will download file from server, write it to flash and reboot.