Phicomm K2P C1

multiple revisions of this device, use caution

abgn+ac (AC1200)
AC1200 Smart Wi-Fi Router
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Phicomm K2P (C1)
FCC ID	none specified
Type	wireless router
CPU1 Y	MediaTek MT7621A
CPU1 Type	MIPS 1004Kc
CPU1 Speed	880 MHz ( 2 cores ) 16-bit
Flash1 Chip	Brand? Model?
Flash1 Size	16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br />
RAM1 Size	128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br />
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7621A
Switch	MediaTek MT7621A
Ethernet Port Count	1-1GbE-WAN 4-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	none specified
Power	12 VDC, 1.5 A
Serial Port (UART)	yes, 3.3V TTL, (57600 8N1)
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Radio 1
Chip1	MediaTek MT7615D
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7615D
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 867 Mbps
802.11n	up to 300 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz
CPU1 brand Radio1 chip1 brand Radio2 chip1 brand Phicomm K2 PSG1218 rev A MediaTek MediaTek MediaTek Phicomm K2 PSG1218 rev B MediaTek MediaTek MediaTek Phicomm K2G MediaTek MediaTek MediaTek Phicomm K2P MediaTek MediaTek MediaTek Phicomm K2P B1 Broadcom Broadcom Broadcom Phicomm K2P C1 MediaTek MediaTek MediaTek Phicomm K2T Qualcomm Atheros Qualcomm Atheros Qualcomm Atheros

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented Phicomm devices with specifications, see Phicomm.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),

• 867 Mbps - 2SS 5GHz 802.11ac (80MHz chan.) = AC1200 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki

Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 18.06.0
Current supported version: 25.12.2

Unsupported Functions:
Concurrent 2.4GHz and 5GHz WiFi
LAN Hardware: MediaTek MT7621A
WLAN Hardware: MediaTek MT7615D
WLAN Comment: Concurrent operation on 2.4 GHz and 5 GHz not yet supported by the driver
Installation method(s):
U-Boot TFTP + serial recovery
Recovery method(s):
U-Boot TFTP + serial recovery
Comment:
Same as K2P, but renamed for the European market

git • >>

ramips: add support for Phicomm K2P It uses one MT7615D radio chip with DBDC mode enabled. This mode allows this single chip act as an 2x2 11n radio and an 2x2 11ac radio at the same time. However mt76 doesn't support it currently so there is no wireless available. Specification: - SoC: MediaTek MT7621AT - Flash: 16 MB - RAM: 128 MB - Ethernet: 1 x WAN (10/100/1000Mbps) and 4 x LAN (10/100/1000 Mbps) - Wireless radio: MT7615D on PCIE0 - UART: 1 x UART on PCB - 57600 8N1 Issue: - Wireless radio doesn't work due to the lack of driver. Flash instruction: Using UART: 1. Configure PC with a static IP address and setup an TFTP server. 2. Put the firmware into the tftp directory. 3. Connect the UART line as described on the PCB. 4. Power up the device and press 2,then follow the instruction to set device and tftp server IP address and input the firmware file name.U-boot will then load the firmware and write it into the flash. Signed-off-by: Chuanhong Guo