RAVPower FileHub Plus

multiple revisions of this device, use caution

bgn (N300)
Wireless Travel Router
Homepage	Product page
WikiDevi.wi-cat.ru	RAVPower FileHub Plus
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	RAVPower FileHub Plus
Model Part Number	RP-WD03
FCC ID	2ACIP-RP-WD03
Type	travel router, access point
CPU1 Y	MediaTek MT7620N
CPU1 Type	MIPS 24KEc
CPU1 Speed	580 MHz
Flash1 Chip	Holtek HT66F40
Flash1 Size	8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br />
RAM1 Size	32 MiB 33,554,432 B <br />262,144 Kib <br />32,768 KiB <br />256 Mib <br />0.0313 GiB <br />
RAM1 Chip	PM Tech PMD708416CTR-5CN
ETH chip1	MediaTek MT7620N
Ethernet Port Count	1-100MbE-LAN
Wired Standard	IEEE 802.3i/3u
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	USB 2.0, SD Card slot
USB ports	1
SD/MMC Slots	1
USB Hub Compatible	Untested
Power	5 VDC, 1 A ?v BAT , 6000 mAh, ? cells
Connector type	USB Female (Micro-B)
Serial Port (UART)	yes, (57600 8N1)
Other
Manuf/OEM/ODM	HooToo
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Retail
FCC approval date	12 May 2015
ASIN	B016ZWS9ZE
Country of manuf	China
Radio 1
Chip1	MediaTek MT7620N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
CPU1 brand Radio1 chip1 brand Radio1 chip2 brand RAVPower FileHub Plus MediaTek MediaTek RAVPower Filehub (RP-WD02) Ralink Ralink

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented RAVPower devices with specifications, see RAVPower.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.) = N300 class

Overview

Built-in 6000mAh power bank (5V/1A, 2x Samsung 18650 Battery Cells)

SD Card USB Reader & 6000mAh Portable Charger

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki

Target: ramips
Subtarget: mt7620
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 18.06.0
Current supported version: fix

WLAN Hardware: MediaTek MT7620N
Installation method(s):
TFTP generic, Sysupgrade, see git-commit
Install Comment:
Rename files to "kernel" and "rootfs" accordingly
Recovery method(s):
TFTP generic

git • >>

ramips: add support for Ravpower WD03 The RavPower WD03 is a battery powered SD card reader and a USB port. Specifications: SOC: MediaTek MT7620N BATTERY: 6000mah WLAN: 802.11bgn LAN: 1x 10/100 Mbps Ethernet USB: 1x USB 2.0 (Type-A) RAM: PM Tech PMD708416CTR-5CN 32 MB FLASH: Holtek HT66F40 - 8 MB Flash LED: Power button and 4 leds to indicate power level of the battery (could not get control of that) INPUT: Power, reset button OTHER: USB SD-Card reader with card detect on GPIO#42 Tested and working: - Ethernet - 2.4 GHz WiFi (Correct MAC-address) - installation from tftp - OpenWRT sysupgrade (Preserving and non-preserving) - LEDs - Buttons Installation: - Download the sysupgrade image - Place it in the root of a clean TFTP server running on your computer. - Rename the image to "kernel" — be sure there is no file extension. - Plug the WD03 into your computer via ethernet. - Set your computer to use 10.10.10.254 as its IP address. - With your WD03 shut down, hold down the power button until the first white LED lights up. - Push and hold the reset button and release the power button. Continue holding the reset button for 30 seconds or until it begins searching for files on your TFTP server, whichever comes first. - The WD03 (10.10.10.128) will look for your computer at 10.10.10.254 and install the kernel file. Once it has finished installation of the kernel file, it will search for a (nonexistent) rootfs file — when it begins searching for this file, shut down the WD03 by holding the power button normally. - Start up your WD03 normally. Signed-off-by: Matthias Badaire