RAVPower RP-WD009
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC750) | |
|---|---|
| Wireless Travel Router AC750 | |
|
| |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Supported |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | RAVPower RP-WD009 |
| FCC ID | none specified |
| Type | travel router |
| CPU1 | MediaTek MT7628AN |
| CPU1 Type | MIPS 24KEc |
| CPU1 Speed | 580 MHz |
| Flash1 Chip | Brand? Model? |
| Flash1 Size | 16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> (SPI NOR) |
| RAM1 Size | 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> (DDR2) |
| RAM1 Chip | Brand? Model? |
| ETH chip1 | MediaTek MT7628AN |
| Ethernet Port Count | 1-100MbE-LAN |
| Wired Standard | IEEE 802.3i/3u |
|
802dot11 OUI: none specified | |
| Stock bootloader | U-Boot |
| Expansion IF types | SD Card, USB 2.0 |
| USB ports | 1 |
| SD/MMC Slots | 1 |
| USB Hub Compatible | Untested |
| Power |
5 VDC, 2 A ?v BAT , 6700 mAh, ? cells |
| Connector type | (USB Type-C) |
| Serial Port (UART) | yes, (57600 8N1) |
|
| |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Radio 1 | |
| Chip1 | MediaTek MT7628AN |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 300 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | MediaTek MT7610E |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 1x1:1 |
| Wireless Standard | IEEE 802.11a/n/ac |
| 802.11ac | up to 433 Mbps |
| 802.11n | up to 150 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
For a list of all currently documented RAVPower devices with specifications, see RAVPower.
Overview
The RAVPower RP-WD009 is a batter-powered pocket sized router with SD card lot and USB port.
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
| This device is NOT RECOMMENDED for future use with OpenWrt due to low flash/ram.
DO NOT BUY DEVICES WITH 8MB FLASH / 64MB RAM if you intend to flash an up-to-date and secure OpenWrt version onto it! See 8/64 warning for details. This device does not have sufficient resources (flash and/or RAM) to provide secure and reliable operation. This means that you will not be able to install many packages, and that you might experience crashes due to OOM situations more or less often. See OpenWrt on 8/64 devices what you can do now. |
Target: ramips
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.2
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.2
WLAN Hardware: MediaTek MT7628AN, MediaTek MT7610E
WLAN Comment: 2.4Ghz 2x2:2 MIMO, 5Ghz 1x1:1 MIMO
Installation method(s):
TFTP generic, see git-commit
Recovery method(s):
TFTP generic
WLAN Comment: 2.4Ghz 2x2:2 MIMO, 5Ghz 1x1:1 MIMO
Installation method(s):
TFTP generic, see git-commit
Recovery method(s):
TFTP generic
| git • >> |
|---|
ramips: add support for RAVPower RP-WD009
The RAVPower RP-WD009 is a batter-powered pocket sized router with SD
card lot and USB port.
Hardware
--------
CPU: MediaTek MT7628AN
RAM: 64M DDR2
FLASH: 16M GigaDevices SPI-NOR
WLAN: MediaTek MT7628AN 2T2R b/g/n
MediaTek MT7610E 1T1R n/ac
ETH: 1x FastEthernet
SD: SD Card slot
USB: USB 2.0
Custom PMIC on the I2C bus (address 0x0a).
Installation
------------
1. Press and hold down the reset button.
2. Power up the Device. Keep pressing the reset button for 10
more seconds until the Globe LED lights up.
3. Attach your Computer to the Ethernet port. Assign yourself the
address 10.10.10.1/24.
4. Access the recovery page at 10.10.10.128 and upload the OpenWrt
factory image.
5. The flashing will take around 1 minute. The device will reboot
automatically into OpenWrt.
|
Categories:
- RAVPower
- Embedded system/travel router
- Embedded System MediaTek
- Embedded System MT7628AN
- MediaTek
- Embedded System MIPS 24KEc
- Embedded System
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System MT7610E
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation