RFNet APRT-2001g

From TechInfoDepot
Jump to navigationJump to search
bg (G54)
wireless router
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Status Unknown
Tomato any flavor Incompatible
Platform
BrandModelRev RFNet APRT-2001g
FCC ID PXP000002
Type wireless router
CPU1 checkY Atheros AR2312A
CPU1 Type MIPS 4Kc
CPU1 Speed 180 MHz
Flash1 Chip Brand? Model?
Flash1 Size ? MiB
RAM1 Size ? MiB
RAM1 Chip Brand? Model?
ETH chip1 Atheros AR2312A
Switch Marvell 88E6060
Ethernet Port Count 1-WAN
4-100MbE-LAN
Wired Standard IEEE 802.3i/3u

802dot11 OUI: 00:06:C7
Ethernet OUI: 00:06:C7

Expansion IF types none specified
Power 9 VDC, 1 A
Connector type barrel

Flags:
block diagram

Additional chips
2.4GHz Power Amplifier IC;Microsemi;LX5510;;1;

Other

Default SSID: 11g (2 addl. devices)
Default IP address: 10.0.0.1
the IP 10.0.0.1 is used by 21 additional devices
of which 0 are RFNet devices

Retail
FCC approval date 04 February 2004
Radio 1
Chip1 Atheros AR2312A
Chip2 Atheros AR2112A
Wireless interface OUI 00:06:C7
Antenna Connector Type RP-SMA
Wireless Standard IEEE 802.11b/g
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Marvell chipsets with specifications, see Marvell.

For a list of all currently documented RFNet devices with specifications, see RFNet.

54 Mbps - 2.4GHz 802.11g = G54 class

Overview

The i-connect AP880G and Aztech NA8300 would seem to use the same board as this device.

Default settings (including the SSID) are per the FCC manual.

A 00:06:C7 (RFNet) OUI is presumed to be used (it's shown on a MAC label affixed to the EUT) - there is support for it within WiGLE

The power supply shown in the external photos is an unbranded SY-0901 (120VAC ~ 60Hz, 150mA -> 9VDC, 1.0A).