Ruijie RG-X60 PRO
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac+ax (AX6000) | |
|---|---|
|
Ruijie Scorpio E-Sports Wifi6 Router AX6000 Dual-Band Wi-Fi 6 Router | |
 | |
| WikiDevi.wi-cat.ru | Ruijie RG-X60 Pro |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Supported |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | Ruijie RG-X60 PRO |
| FCC ID | none specified |
| Type | wireless router |
CPU1  | MediaTek MT7986AV |
| CPU1 Type | ARM Cortex-A53 |
| CPU1 Speed | 2.0 GHz ( 4 cores ) 64-bit |
| Flash1 Chip | Winbond W25N01GVZEIG |
| Flash1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI-NAND) |
| RAM1 Size | 512 MiB 536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br /> (DDR3) |
| RAM1 Chip | Winbond W634GU6QB |
| ETH chip1 | MediaTek MT7986AV |
| ETH chip2 | Realtek RTL8221B |
| Switch | MediaTek MT7531AE |
| Ethernet Port Count |
4-2.5GbE-WAN 4-1GbE-LAN |
| Wired Standard | IEEE 802.3i/3u/3ab/3bz |
| Stock bootloader | U-Boot |
| Expansion IF types | none specified |
| Power | 12 VDC, 3 A |
| Connector type | barrel |
| Serial Port (UART) | yes, 3.3V TTL, (115200 8N1) |
|
Flags: | |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Radio 1 | |
| Chip1 | MediaTek MT7986AV |
| Chip2 | MediaTek MT7975N |
| Wireless interface OUI | 10:82:3D |
| Antenna Connector Type | none specified |
| MIMO status | 4x4:4 |
| Wireless Standard | IEEE 802.11b/g/n/ax |
| 802.11ax | up to 1148 Mbps |
| 802.11n | up to 600 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | MediaTek MT7986AV |
| Chip2 | MediaTek MT7975PN |
| Wireless interface OUI | 10:82:3D |
| Antenna Connector Type | none specified |
| MIMO status | 4x4:4 |
| Wireless Standard | IEEE 802.11a/n/ac/ax |
| AX-QAM | up to 4804 Mbps |
| 802.11ax | up to 2402 Mbps |
| 802.11ac | up to 867 Mbps |
| 802.11n | up to 600 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
For a list of all currently documented Realtek chipsets with specifications, see Realtek.
For a list of all currently documented Ruijie devices with specifications, see Ruijie.
Flashing
 | NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
Target: mediatek
Subtarget: filogic
Package architecture: aarch64_cortex-a53
Supported Since Commit
Support started version: 24.10.0
Current supported version: fix
Subtarget: filogic
Package architecture: aarch64_cortex-a53
Supported Since Commit
Support started version: 24.10.0
Current supported version: fix
LAN Hardware: MediaTek MT7531AE
LAN Comment: Realtek RTL8221B 2.5Gbe Phy
WLAN Hardware: MediaTek MT7986A, MediaTek MT7976GN, MediaTek MT7976AN
WLAN Comment: MIMO 4x4:4 on both bands
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
LAN Comment: Realtek RTL8221B 2.5Gbe Phy
WLAN Hardware: MediaTek MT7986A, MediaTek MT7976GN, MediaTek MT7976AN
WLAN Comment: MIMO 4x4:4 on both bands
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
| git • >> |
|---|
mediatek: add support for Ruijie RG-X60 Pro
This pull request ports Ruijie RG-X60 Pro router support to the main branch.
Parameters:
- SoC : MediaTek MT7986A Quad-core ARM Cortex-A53 2.0GHz
- RAM : DDR3 512MiB (W634GU6QB)
- Flash : SPI-NAND 128 MiB (W25N01GVZEIG)
- WLAN : MediaTek MT7986A integration dual-band WiFi 6
- 2.4 GHz : b/g/n/ax, MIMO 4x4
- 5 GHz : a/n/ac/ax, MIMO 4x4
- Ethernet : 10/100/1000 Mbps x4 (MediaTek MT7531AE)
2500Mbps x 1 (Realtek RTL8221B-VB-CG)
- UART : through-hole on PCB
- [J500] GND, TX, RX, 3.3V (115200n1)
- Buttons : Mesh, Reset
- LEDs : 1x Power (Blue)
1x Turbo (Purple)
- Power : 12 VDC, 3 A
How to Installation:
1. Remove the case and connect the TTL cable to the corresponding position.
2. Power on the device and quickly press "down" on the keyboard, then
U-Boot will stay in the menu.
3. Select "1. Upgrade Firmware", select "0. TFTP Client(Default)".
4. Input the IP address, input the Openwrt image file name to be
flashed, start the TFTP server, and press "Enter".
5. Wait for the flashing to complete.
How return to stock:
1. Remove the case and connect the TTL cable to the corresponding
position.
2. Power on the device and quickly press "down" on the keyboard, then
U-Boot will stay in the menu.
3. Select "1. Upgrade Firmware", select "0. TFTP Client(Default)".
4. Input the IP address, input the Stock “E-WEBOS” image file name to
be flashed, start the TFTP server, and press "Enter".
5. Wait for the flashing to complete.
About recovery:
Connect uart, use u-boot menu to flash stock firmware image or boot
OpenWrt initramfs image.
About MAC Address:
+---------+-------------------+-----------+
| | MAC | Algorithm |
+---------+-------------------+-----------+
| WAN | 10:82:3D:XX:XX:9E | label |
| LAN | 10:82:3D:XX:XX:9F | label+1 |
| WLAN 2g | 10:82:3D:XX:XX:A0 | label+2 |
| WLAN 5g | 10:82:3D:XX:XX:A1 | label+3 |
+---------+-------------------+-----------+
|
Categories:
- Ruijie
- Embedded system/wireless router
- Embedded System MediaTek
- Embedded System MT7986AV
- MediaTek
- Embedded System ARM
- Embedded System Cortex-A53
- Embedded System RTL8221B
- Embedded System Realtek
- Realtek
- Embedded System MT7531AE
- OpenWrt Supported
- Embedded System MT7975N
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n/ax
- Embedded System MT7975PN
- Embedded System IEEE 802.11a/n/ac/ax
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- Embedded System
- English Documentation
