Sony Ericsson GC89
From TechInfoDepot
Jump to navigationJump to search
| bg (G54) | |
|---|---|
|
| |
| Platform | |
| Brand • Model • Rev | Sony Ericsson GC89 |
| Interface | PCMCIA (32-bit) |
| Connector | PCMCIA (32-bit) |
|
ID:14e4:4325 (2 addl. devices) SS: 18de:0003 | |
|
| |
| FCCID | PY7FF051011 |
| ICID | 4170B-FF051011 |
|
| |
| Chip1 | Broadcom BCM4306 |
| Chip2 | Broadcom BCM2050 |
|
OUI: 00:1B:59 | |
| Wireless Standards | IEEE 802.11b/g |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| Operating Frequency | 2.4 GHz |
|
| |
|
Probable Linux driver | |
| Retail | |
| FCC approval date | 03 May 2005 |
| Country of manuf | Malaysia, Mexico |
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
- • 54 Mbps - 2.4GHz 802.11g = G54 class
Overview
lspci -nnv dump
06:00.0 Network controller [0280]: Broadcom Corporation BCM4306 802.11bg Wireless Network Controller [14e4:4325] (rev 03)
Subsystem: Device [18de:0003]
Flags: bus master, fast devsel, latency 64, IRQ 19
Memory at f1d00000 (32-bit, non-prefetchable) [size=8K]
Kernel driver in use: b43-pci-bridge
06:00.1 Serial controller [0700]: Broadcom Corporation EDGE/GPRS data and 802.11b/g combo cardbus [GC89] [14e4:4344] (rev 03) (prog-if 02 [16550])
Subsystem: Device [18de:0003]
Flags: fast devsel, IRQ 19
I/O ports at 4000 [size=256]
Kernel driver in use: serial
ssb + b43 dump
[39678.329606] ssb: Found chip with id 0x4306, rev 0x03 and package 0x00 [39678.329616] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x04, vendor 0x4243) [39678.329626] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x05, vendor 0x4243) [39678.329636] ssb: Core 2 found: PCMCIA (cc 0x80D, rev 0x02, vendor 0x4243) [39678.329645] ssb: Core 3 found: V90 (cc 0x807, rev 0x02, vendor 0x4243) [39678.329655] ssb: Core 4 found: PCI (cc 0x804, rev 0x09, vendor 0x4243) [39678.333419] b43-phy27: Broadcom 4306 WLAN found (core revision 5) [39678.356380] b43-phy27: Found PHY: Analog 2, Type 2 (G), Revision 2 [39678.380512] ssb: Sonics Silicon Backplane found on PCI device 0000:06:00.0 [39678.380555] serial 0000:06:00.1: enabling device (0000 -> 0001) [39678.401672] 0000:06:00.1: ttyS4 at I/O 0x4000 (irq = 19) is a 16550A [39678.401871] ieee80211 phy27: Selected rate control algorithm 'minstrel_ht' [39678.439783] cfg80211: Calling CRDA for country: US [39678.447546] cfg80211: Regulatory domain changed to country: US [39678.447550] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [39678.447553] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) [39678.447555] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) [39678.447556] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [39678.447558] cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [39678.447560] cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [39678.447561] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) [39678.447562] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 4000 mBm) [39678.620343] b43-phy27: Loading firmware version 666.2 (2011-02-23 01:15:07) [39678.681307] IPv6: ADDRCONF(NETDEV_UP): wlan133: link is not ready