TP-LINK Archer MR200 v5

multiple revisions of this device, use caution

abgn+ac (AC750)
AC750 Wireless Dual Band 4G LTE Router
Wikipedia	TP-Link
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	TP-LINK Archer MR200 v5
FCC ID	none specified
Type	wireless router
CPU1 Y	MediaTek MT7628AN
CPU1 Type	MIPS 24KEc
CPU1 Speed	580 MHz
Flash1 Chip	Brand? Model?
Flash1 Size	8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (SPI NOR)
RAM1 Size	64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> (DDR2)
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7628AN
Switch	MediaTek MT7628AN
Ethernet Port Count	4-100MbE-LAN
Wired Standard	IEEE 802.3i/3u
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	sim
SIM Card slot	1
Power	12 VDC, 1 A
Connector type	barrel
Serial Port (UART)	yes, 3.3V TTL, (115200 8N1)
Flags: LTE
Other
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Radio 1
Chip1	MediaTek MT7628AN
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7610E
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	1x1:1
Wireless Standard	IEEE 802.11a/n/ac
802.11ac	up to 433 Mbps
802.11n	up to 150 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz
CPU1 brand Radio1 chip1 brand Radio2 chip1 brand TP-LINK Archer MR200 MediaTek MediaTek MediaTek TP-LINK Archer MR200 v5 MediaTek MediaTek MediaTek TP-LINK Archer MR200 v6 MediaTek MediaTek MediaTek

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented TP-LINK devices with specifications, see TP-LINK.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),

• 433 Mbps - 1SS 5GHz 802.11ac (80MHz chan.) = AC750 class

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)

Target: ramips
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 24.10.0
Current supported version: 25.12.2

LAN Hardware: MediaTek MT7628AN
LAN Comment: Qualcomm MDM9207 LTE Modem
WLAN Hardware: MediaTek MT7628AN, MediaTek MT7610E
WLAN Comment: 2.4GHz: 2x2:2 MIMO, 5Ghz: 1x1:1 MIMO
Installation method(s):
see git-commit
Recovery method(s):
see git-commit

git • >>

ramips: add support for TP-Link Archer MR200v5 Specifications: CPU: MT7628AN 580MHz RAM: 64MB DDR2 FLASH: 8MB EN25QH64 NOR SPI WIFI: 2.4GHz 2x2 MT7628 b/g/n internal WIFI: 5GHz 1x1 MT7610E ac/n PCI LTE: Qualcomm MDM9207 ETH: 4xLAN 100base-T integrated SWITCH: RT3050-ESW Port 0,1,2,3: LAN, Port 6: CPU LEDS: LAN, WAN, Power, 3x signal strength, WiFi BTNS: Reset, WiFi toggle UART: Near ETH ports, Vcc-GND-RX-TX, 115200, 8N1 Installation: 1. Update using recovery mode - set your IP to 192.168.0.225, subnet mask: 255.255.255.0 - start tftp server, rename tftp-recovery.bin to tp_recovery.bin and place it into the server's directory - while holdig the "reset" button, power on the device - keep holding "reset" until the file is being transferred Notes: This board has only one MAC address programmed in the "romfile" partition: - MAC for phy0 (2.4GHz) at romfile 0xf100 (0) - MAC for phy1 (5GHz) at romfile 0xf100 (-1) - stock firmware re-uses phy0 MAC for ethernet - stock firmware uses romfile 0xf100 (1) for WWAN; not used since QMI interface is raw IP