TP-LINK TL-WA1201 v2
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC1200) | |
|---|---|
| AC1200 Wireless Access Point | |
|
| |
| Homepage | Product page |
| Wikipedia | TP-Link |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Partial Support |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | TP-LINK TL-WA1201 v2 |
| FCC ID | TE7WA1201V2 |
| Type | access point |
| CPU1 | Qualcomm Atheros QCA9563 |
| CPU1 Type | MIPS 74Kc |
| CPU1 Speed | 775 MHz |
| Flash1 Chip | Brand? Model? |
| Flash1 Size | 16 MiB 16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> (SPI NOR) |
| RAM1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (DDR2) |
| RAM1 Chip | Brand? Model? |
| ETH chip1 | Qualcomm Atheros QCA9563 |
| ETH chip2 | Atheros AR8033 |
| Ethernet Port Count | 1-1GbE-LAN |
| Wired Standard | IEEE 802.3i/3u/3ab |
|
802dot11 OUI: none specified | |
| Stock bootloader | U-Boot |
| Expansion IF types | none specified |
| Power | 12 VDC, 1.5 A |
| Serial Port (UART) | yes, 3.3V TTL, (115200 8N1) |
|
| |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Radio 1 | |
| Chip1 | Qualcomm Atheros QCA9563 |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 300 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | Qualcomm Atheros QCA9886 |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11a/n/ac |
| 802.11ac | up to 867 Mbps |
| 802.11n | up to 300 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.
For a list of all currently documented TP-LINK devices with specifications, see TP-LINK.
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
Target: ath79
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 22.03.0
Current supported version: 25.12.1
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 22.03.0
Current supported version: 25.12.1
Unsupported Functions:
wifi dfs channels (52+)
LAN Comment: Atheros AR8033 GbE Phy
WLAN Hardware: Qualcomm Atheros QCA9563, Qualcomm Atheros QCA9886
Installation method(s):
GUI OEM, see git-commit
Recovery method(s):
U-Boot TFTP + serial recovery
Comment:
available ram is either 64MB (fcc image) or 128MB (attached bootlog on device page)
wifi dfs channels (52+)
LAN Comment: Atheros AR8033 GbE Phy
WLAN Hardware: Qualcomm Atheros QCA9563, Qualcomm Atheros QCA9886
Installation method(s):
GUI OEM, see git-commit
Recovery method(s):
U-Boot TFTP + serial recovery
Comment:
available ram is either 64MB (fcc image) or 128MB (attached bootlog on device page)
| git • >> |
|---|
ath79: add support for TP-Link TL-WA1201 v2
This device is a wireless access point working on the 2.4 GHz and 5 GHz
band, based on Qualcomm/Atheros QCA9563 + QCA9886.
Specification
- 775 MHz CPU
- 128 MB of RAM (DDR2)
- 16 MB of FLASH (SPI NOR)
- QCA9563: 2.4 GHz 3x3
- QCA9886: 5 GHz
- AR8033: 1x 1 Gbs Ethernet
- 4x LED, WPS factory reset and power button
- bare UART on PCB (accessible through testpoints)
Methods for Flashing:
- Apply factory image in OEM firmware web-gui. Wait a minute after the
progress bar completes and restart the device.
- Sysupgrade on top of existing OpenWRT image
- Solder wires onto UART testpoints and attach a terminal.
Boot the device and press enter to enter u-boot's menu. Then issue the
following commands
1. setenv serverip your-server-ip
setenv ipaddr your-device-ip
2. tftp 0x80060000 openwrt-squashfs.bin (Rembember output of size in
hex, henceforth "sizeinhex")
3. erase 0x9f030000 +"sizeinhex"
4. cp.b 0x80060000 0x9f030000 0x"sizeinhex"
5. reboot
Recover:
- U-boot serial console
|
Categories:
- TP-LINK
- Embedded system/access point
- Embedded System Qualcomm Atheros
- Embedded System QCA9563
- Qualcomm Atheros
- Embedded System MIPS 74Kc
- Embedded System
- Embedded System AR8033
- Embedded System Atheros
- Atheros
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System QCA9886
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation