TP-LINK WBS210 v2

From TechInfoDepot
Jump to navigationJump to search
multiple revisions of this device, use caution
bgn (N300)
2.4GHz 300Mbps Outdoor Wireless Base Station
Homepage Product page
Wikipedia TP-Link
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Supported
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
Brand • Model • Rev TP-LINK WBS210 v2
FCC ID none specified
Type access point
CPU1 checkY Atheros AR9344
CPU1 Type MIPS 74Kc
CPU1 Speed 560 MHz 32-bit
Flash1 Chip Brand? Model?
Flash1 Size 8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (SPI NOR)
RAM1 Size 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br />
RAM1 Chip Brand? Model?
ETH chip1 Atheros AR9344
Switch Atheros AR9344
Ethernet Port Count 2-100MbE-LAN
Wired Standard IEEE 802.3i/3u

802dot11 OUI: none specified

Stock bootloader U-Boot
Expansion IF types none specified
PoE Passive
Power 16-27 VDC, ? A
Other
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Radio 1
Chip1 Atheros AR9344
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11b/g/n
802.11n up to 300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz
 CPU1 brandRadio1 chip1 brandRadio1 chip2 brand
TP-LINK WBS210 v1AtherosAtheros
TP-LINK WBS210 v2AtherosAtheros

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.

For a list of all currently documented TP-LINK devices with specifications, see TP-LINK.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.) = N300 class

Flashing

Flashing OpenWrt

Target: ath79
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.0
LAN Hardware: Atheros AR9344
WLAN Hardware: Atheros AR9344
WLAN Comment: 2x2:2 MIMO
Installation method(s):
GUI OEM, U-Boot TFTP recovery, see git-commit
Recovery method(s):
U-Boot TFTP recovery, see git-commit
git • >>
ath79: add support for TP-Link WBS210 v2
TP-Link WBS210 v2 is an outdoor wireless CPE for 2.4 GHz with
two Ethernet ports based on Atheros AR9344

The device is the same as TP-Link CPE220 v2, but with higher TX power (27 dBm
instead of 12 dBm) and two antenna connectors instead of built-in antennas.

Specifications:
 - SoC: Atheros AR9344
 - RAM: 64MB
 - Storage: 8 MB SPI NOR
 - Wireless: 2.4GHz 300 Mbps, 2x RP-SMA connector, 27 dBm TX power
 - Ethernet: 1x 10/100 Mbps with 24V POE IN, 1x 10/100 Mbps

Installation:
Flash factory image through stock firmware WEB UI
or through TFTP
To get to TFTP recovery just hold reset button while powering on for
around 4-5 seconds and release.
Rename factory image to recovery.bin
Stock TFTP server IP: 192.168.0.100
Stock device TFTP adress: 192.168.0.254

The TP-Link WBS devices use the same GPIOs as the CPE devices,
except for the link4 LED. For this one, WBS devices use "2", while
CPE devices use "16". (Tested on WBS210 v2)