Ubiquiti Networks EdgeSwitch 5XP (ES-5XP)
From TechInfoDepot
Jump to navigationJump to search
| EdgeSwitch 5XP | |||||||||||||
|
| |||||||||||||
| 3rd Party Firmware | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| dd-wrt | Status Unknown | ||||||||||||
| OpenWrt | Supported | ||||||||||||
| Tomato any flavor | Incompatible | ||||||||||||
| Gargoyle | Status Unknown | ||||||||||||
| Platform | |||||||||||||
| Brand • Model • Rev | Ubiquiti Networks EdgeSwitch 5XP (ES-5XP) | ||||||||||||
| CPU1 | Atheros AR7242 | ||||||||||||
| CPU1 Type | MIPS 24Kc | ||||||||||||
| CPU1 Speed | 400 MHz 32-bit | ||||||||||||
| Bus | 32-bit | ||||||||||||
| Flash1 Size | 8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> | ||||||||||||
| RAM1 Size | 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> | ||||||||||||
| ETH chip1 | Atheros AR7242 | ||||||||||||
| Switch | Atheros AR7242 | ||||||||||||
| Ethernet Port Count | 5-1GbE | ||||||||||||
| Ethernet connector | 8P8C | ||||||||||||
| Wired Standard | IEEE 802.3i/3u/3ab | ||||||||||||
| Auto-MDIX | unspecified | ||||||||||||
| Switch Class | managed | ||||||||||||
|
Ethernet OUI: none specified | |||||||||||||
| Expansion IF types | USB 2.0 | ||||||||||||
| Stock bootloader | U-Boot | ||||||||||||
| PoE | passive | ||||||||||||
| Power | 24 VDC, ? A | ||||||||||||
| Serial Port (UART) | yes, 3.3V TTL, (115200 8N1) | ||||||||||||
|
| |||||||||||||
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) | ||||||||||||
| |||||||||||||
For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Ubiquiti Networks devices with specifications, see Ubiquiti Networks.
Overview
The Ubiquiti ToughSwitch 5XP is a 5-port PoE Gigabit switch with a single Fast-Ethernet management port. It supports both 24V passive PoE out on all five ports.
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
| This device is NOT RECOMMENDED for future use with OpenWrt due to low flash/ram.
DO NOT BUY DEVICES WITH 8MB FLASH / 64MB RAM if you intend to flash an up-to-date and secure OpenWrt version onto it! See 8/64 warning for details. This device does not have sufficient resources (flash and/or RAM) to provide secure and reliable operation. This means that you will not be able to install many packages, and that you might experience crashes due to OOM situations more or less often. See OpenWrt on 8/64 devices what you can do now. |
Target: ath79
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.0
Subtarget: generic
Package architecture: mips_24kc
Supported Since Commit
Support started version: 21.02.0
Current supported version: 25.12.0
LAN Hardware: Atheros AR8327
WLAN Comment: No WLAN
Installation method(s):
GUI OEM, see git-commit
WLAN Comment: No WLAN
Installation method(s):
GUI OEM, see git-commit
| git • >> |
|---|
ath79: add support for Ubiquiti EdgeSwitch/ToughSwitch 5XP The Ubiquiti ToughSwitch 5XP is a 5-port PoE Gigabit switch with a single Fast-Ethernet management port. It supports both 24V passive PoE out on all five ports. Flash: 8 MB RAM: 64 MB SoC: AR7242 Switch: ar8327 USB: 1x USB 2.0 Ethernet: 5x GbE, 1x FE Installation of the firmware is possible either via serial + tftpboot or the factory firmware update function via webinterface. By default the single Fast-Ethernet port labeled "MGMT" is configured as the WAN port. Thus access to the device is only possible via the five switch ports. Serial: 3v3 115200 8n1 The serial header is located in the lower left corner of the switches PCB: ``` | | | | o | o RX | o TX | o GND | | ++ +-++-+ ++ ++ + +--+ ++ +--++--++--+ ``` |