WAVLINK WL-WN575A3B
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC1200) | |
|---|---|
| AC1200 Dual Band WiFi Range Extender, Repeater / Access Point / Router / Media Bridge | |
 | |
| Homepage | Product page |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Supported |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | WAVLINK WL-WN575A3B |
| FCC ID | none specified |
| Type | range extender |
CPU1  | MediaTek MT7628AN |
| CPU1 Type | MIPS 24KEc |
| CPU1 Speed | 580 MHz |
| Flash1 Chip | GigaDevice GD25Q64B |
| Flash1 Size | 8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (Serial) |
| RAM1 Size | 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> (DDR2) |
| RAM1 Chip | Brand? Model? |
| ETH chip1 | MediaTek MT7628AN |
| Switch | Ralink RT3050 |
| Ethernet Port Count | 2-100MbE-LAN |
| Wired Standard | IEEE 802.3i/3u |
|
802dot11 OUI: none specified | |
| Stock bootloader | U-Boot |
| Expansion IF types | none specified |
| Power | 100-240 VAC ~ 50/60 Hz, ? A |
| Connector type | AC (direct) |
| Serial Port (UART) | no |
|
| |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Retail | |
| Availability | End of Life |
| Physical | |
| Dimensions | 72mm x 50mm x 25mm ( L x W x H ) |
| Radio 1 | |
| Chip1 | MediaTek MT7628AN |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 300 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | MediaTek MT7612E |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11a/n/ac |
| 802.11ac | up to 867 Mbps |
| 802.11n | up to 300 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
For a list of all currently documented Ralink chipsets with specifications, see Ralink.
For a list of all currently documented WAVLINK devices with specifications, see WAVLINK.
Overview
The WAVLINK WL-WN575A3 is an AC1200 WiFi range extender based on the MediaTek MT7628AN with two Fast Ethernet ports, a 802.11n 2T/2R 2.4 GHz 300Mbps and a 802.11ac 2T/2R 5 GHz 867 Mbps wireless interfaces. On the manufacturer's website it is both referenced as WL-WN575A3 or WL-WN575A3B.
Flashing
 | NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
 | This device is NOT RECOMMENDED for future use with OpenWrt due to low flash/ram.
DO NOT BUY DEVICES WITH 8MB FLASH / 64MB RAM if you intend to flash an up-to-date and secure OpenWrt version onto it! See 8/64 warning for details. This device does not have sufficient resources (flash and/or RAM) to provide secure and reliable operation. This means that you will not be able to install many packages, and that you might experience crashes due to OOM situations more or less often. See OpenWrt on 8/64 devices what you can do now. |
Target: ramips
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 17.01.0
Current supported version: 25.12.2
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 17.01.0
Current supported version: 25.12.2
LAN Hardware: Ralink RT3050
WLAN Hardware: MediaTek MT7628AN, MediaTek MT7612E
WLAN Comment: 2x2:2 MIMO both channels
Installation method(s):
U-Boot TFTP recovery, see devicepage
Recovery method(s):
U-Boot TFTP recovery
WLAN Hardware: MediaTek MT7628AN, MediaTek MT7612E
WLAN Comment: 2x2:2 MIMO both channels
Installation method(s):
U-Boot TFTP recovery, see devicepage
Recovery method(s):
U-Boot TFTP recovery
| git • >> |
|---|
ramips: Add support for Wavlink WL-WN575A3 This commit adds support for the Wavlink WL-WN575A3, a dual-band wall-plug wireless router with the following specifications: - CPU: MediaTek MT7628AN 580MHz - Flash: 8MB - RAM: 64MB - Ethernet: 2x 10/100 Mbps (switched) - 2.4 GHz: 802.11b/g/n SoC, MIMO 2x2, 20 dBm - 5 GHz: 802.11a/n/ac MT7612E, MIMO 2x2, 20 dBm - Antennas: 4x external (2 per radio), non-detachable - LEDs: 4 programmable + LAN, WAN, POWER - Buttons: reset, WPS Flashing instructions: Factory U-boot launches a TFTP client if WPS button is pressed during power-on. Rename the sysupgrade file and configure a TFTP as follows: - Client (WL-WN575A3) IP: 192.168.10.101 - Server IP: 192.168.10.100 - Filename: firmware.bin |
Categories:
- WAVLINK
- Embedded system/range extender
- Embedded System MediaTek
- Embedded System MT7628AN
- MediaTek
- Embedded System MIPS 24KEc
- Embedded System
- Embedded System Ralink
- Embedded System RT3050
- Ralink
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System MT7612E
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation
