ZyXEL NBG6515
From TechInfoDepot
Jump to navigationJump to search
| abgn+ac (AC750) | |
|---|---|
| AC750 Dual-Band Wireless Gigabit Router | |
|
| |
| Homepage | Product page |
| Wikipedia | ZyXEL |
| WikiDevi.wi-cat.ru | ZyXEL NBG6515 |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Partial Support |
| Tomato any flavor | Incompatible |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | ZyXEL NBG6515 (EU0101F) |
| FCC ID (fcc.io) | I88NBG6515 |
| FCC ID (fcc.report) | I88NBG6515 |
| IC ID | 2468C-NBG6515 |
| Type | wireless router |
| CPU1 | MediaTek MT7620A |
| CPU1 Type | MIPS 24KEc |
| CPU1 Speed | 580 MHz 32-bit |
| Flash1 Chip | Macronix Model? |
| Flash1 Size | 8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (SPI) |
| RAM1 Size | 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> |
| RAM1 Chip | Winbond W9751G6KB-25 |
| ETH chip1 | MediaTek MT7620A |
| Switch | MediaTek MT7530WU |
| Ethernet Port Count |
1-WAN 4-1GbE-LAN |
| Wired Standard | IEEE 802.3i/3u/3ab |
|
802dot11 OUI: none specified | |
| Stock bootloader | U-Boot |
| Expansion IF types | USB 2.0 |
| USB ports | 1 |
| USB Hub Compatible | Untested |
| Power | 12 VDC, 1 A |
| Connector type | barrel |
| Serial Port (UART) | yes, 4-pin header, (57600 8N1) |
|
| |
|
| |
| Other | |
|
Default IP address: 192.168.3.1 | |
| Manuf/OEM/ODM | Edimax |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Retail | |
| Availability | common |
| FCC approval date | 28 July 2015 |
| ASINs |
B0136Q9O38 B00YG1BHG0 |
| Country of manuf | China |
| Radio 1 | |
| Chip1 | MediaTek MT7620A |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 2x2:2 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 300 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
| Radio 2 | |
| Chip1 | MediaTek MT7610E |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 1x1:1 |
| Wireless Standard | IEEE 802.11a/n/ac |
| 802.11ac | up to 433 Mbps |
| 802.11n | up to 150 Mbps |
| 802.11a | up to 54 Mbps |
| WiFi Operating Frequency | 5 GHz |
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.
For a list of all currently documented ZyXEL devices with specifications, see ZyXEL.
Overview
- FCC ID: I88NBG6515 (07/28/2015)
"1244-01000999-50Z_ES" is silkscreened on the board in the FCC photos.
Flashing
| NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
| This device is NO LONGER SUPPORTED OR POSSIBLE for future use with OpenWrt. |
OpenWrt Target: ramips
OpenWrt Subtarget: mt7620
OpenWrt Package architecture: mipsel_24kc
Support started version: external image
Current supported version: EOL
OpenWrt Subtarget: mt7620
OpenWrt Package architecture: mipsel_24kc
Support started version: external image
Current supported version: EOL
Unsupported Functions:
WiFi-LEDs
WLAN Hardware: MediaTek MT7620A, MediaTek MT7610EN
WLAN Comment: WLAN working with OpenWrt and a piece of the original firmware (preseve before flashing!)
Install Comment:
Need to connect 3.3V Serial on J1. Pins: closest to USB = VCC (do not connect), GND, TX, RX = towards WPS button; Hold number button down on serial terminal during boot, e.g., 2 to flash image (check options for your bootloader in terminal output) Preserve original firmware before flashing! Needed for WLAN
Comment:
WLAN requires some data extracted from stock firmware *before* flashing; instructions on project page
WiFi-LEDs
WLAN Hardware: MediaTek MT7620A, MediaTek MT7610EN
WLAN Comment: WLAN working with OpenWrt and a piece of the original firmware (preseve before flashing!)
Install Comment:
Need to connect 3.3V Serial on J1. Pins: closest to USB = VCC (do not connect), GND, TX, RX = towards WPS button; Hold number button down on serial terminal during boot, e.g., 2 to flash image (check options for your bootloader in terminal output) Preserve original firmware before flashing! Needed for WLAN
Comment:
WLAN requires some data extracted from stock firmware *before* flashing; instructions on project page
Please insert instructions here
Categories:
- ZyXEL
- Embedded system/wireless router
- Embedded System MediaTek
- Embedded System MT7620A
- MediaTek
- Embedded System MIPS 24KEc
- Embedded System
- Embedded System MT7530WU
- Manuf Edimax
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Embedded System MT7610E
- Embedded System IEEE 802.11a/n/ac
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Dual-Band
- English Documentation