Netgear WAX202

From TechInfoDepot
(Redirected from NETGEAR WAX202)
Jump to navigationJump to search
abgn+ac+ax (AX1800)
Essentials WiFi 6 AX1800 Dual Band Access Point
Homepage Product page
Wikipedia Netgear
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Partial Support
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
Brand • Model • Rev Netgear WAX202
FCC ID PY321100518
Type access point
CPU1 checkY MediaTek MT7621A
CPU1 Type MIPS 1004Kc
CPU1 Speed 880 MHz ( 2 cores ) 16-bit
Flash1 Chip ESMT F59L1G81MB-25T
Flash1 Size 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (NAND)
RAM1 Size 512 MiB 536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br />
RAM1 Chip Nanya NT5CC256M16ER-EK
ETH chip1 MediaTek MT7621A
Switch MediaTek MT7530
Ethernet Port Count 4-1GbE-LAN
Wired Standard IEEE 802.3i/3u/3ab

802dot11 OUI: none specified

Stock bootloader U-Boot
Expansion IF types none specified
Power 12 VDC, 1.5 A
Serial Port (UART) yes, 3.3V TTL, (115200 8N1)
Other
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Radio 1
Chip1 MediaTek MT7915DAN
Chip2 MediaTek MT7975DN
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11b/g/n/ax
802.11ax up to 574 Mbps
802.11n up to 300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz
Radio 2
Chip1 MediaTek MT7915DAN
Chip2 MediaTek MT7975DN
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11a/n/ac/ax
802.11ax up to 1201 Mbps
802.11ac up to 867 Mbps
802.11n up to 300 Mbps
802.11a up to 54 Mbps
WiFi Operating Frequency 5 GHz

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented Netgear devices with specifications, see Netgear.

• 574 Mbps - 2SS 2.4GHz 802.11ax (40MHz chan., 256-QAM),
• 1201 Mbps - 2SS 5GHz 802.11ax (80MHz chan., 1024-QAM) = AX1800 class

Flashing

Flashing OpenWrt

Target: ramips
Subtarget: mt7621
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 22.03.0
Current supported version: 25.12.2
LAN Hardware: MediaTek MT7530
WLAN Hardware: MediaTek MT7915D
Installation method(s):
TFTP generic, GUI OEM, U-Boot TFTP recovery, see git-commit
Recovery method(s):
TFTP generic, U-Boot TFTP recovery, see git-commit
Comment:
No 160 MHz support on 5 GHz.
git • >>
ramips: add support for Netgear WAX202
Netgear WAX202 is an 802.11ax (Wi-Fi 6) router.

Specifications:
* SoC: MT7621A
* RAM: 512 MiB NT5CC256M16ER-EK
* Flash: NAND 128 MiB F59L1G81MB-25T
* Wi-Fi:
  * MT7915D: 2.4/5 GHz (DBDC)
* Ethernet: 4x 1GbE
  * Switch: SoC built-in
* USB: None
* UART: 115200 baud (labeled on board)

Load addresses (same as ipTIME AX2004M):
* stock
  * 0x80010000: FIT image
  * 0x81001000: kernel image -> entry
* OpenWrt
  * 0x80010000: FIT image
  * 0x82000000: uncompressed kernel+relocate image
  * 0x80001000: relocated kernel image -> entry

Installation:
* Flash the factory image through the stock web interface, or TFTP to
  the bootloader. NMRP can be used to TFTP without opening the case.
* Note that the bootloader accepts both encrypted and unencrypted
  images, while the stock web interface only accepts encrypted ones.

Revert to stock firmware:
* Flash the stock firmware to the bootloader using TFTP/NMRP.

References in WAX202 GPL source:
https://www.downloads.netgear.com/files/GPL/WAX202_V1.0.5.1_Source.rar

* openwrt/target/linux/ramips/dts/mt7621-ax-nand-wax202.dts
  DTS file for this device.