Cisco Meraki MR18

abgn (AN600)
Meraki MR18 Cloud Managed AP (MR18-HW)
Homepage	Product page
Wikipedia	Cisco Systems
WikiDevi.wi-cat.ru	Cisco Meraki MR18
3rd Party Firmware
dd-wrt	Status Unknown
OpenWrt	Supported
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Cisco Meraki MR18-HW
Model Part Number	600-26010
FCC ID	UDX-60026010
IC ID	6961A-60026010
Board ID	7016A0670004
Type	access point
CPU1 Y	Qualcomm Atheros QCA9557
CPU1 Type	MIPS 74Kc
CPU1 Speed	775 MHz
Flash1 Chip	SK hynix H27U1G8F2BTR-BC
Flash1 Size	128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (NAND)
RAM1 Size	128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (DDR2)
RAM1 Chip	Nanya NT5TU32M16DG-AC x 2
ETH chip1	Qualcomm Atheros QCA9557
ETH chip2	Atheros AR8035-A
Ethernet Port Count	1-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab
802dot11 OUI: 00:18:0A (9 E, 7 W) Ethernet OUI: 00:18:0A (9 E, 7 W)
Stock bootloader	Meraki Atheros LinuxLoader
Stock FW OS	Linux 3.4.80
Expansion IF types	none specified
PoE	802.3at, 802.3af, standard
Power	12 VDC, 1.5 A
Connector type	barrel
Serial Port (UART)	yes, internal, 4-pin header, populated, J4, 3.3V TTL, (115200 8N1)
JTAG Port	yes, 14-pin header, unpopulated, EJTAG 1.2, J5
Flags: PoE in
Additional chips 802.3at PoE Interface and DC/DC Controller;TI;TPS23754;;1; 2.4GHz Power Amplifier IC;Microchip;SST12LP15B;;2; 800ma Low Dropout Linear Regulator;National Semiconductor;LM1117;;1; 3 Channel 16bit PWM Constant Current Driver;Numen Tech;NU801;;1; 400V 30A Single-Phase Bridge Rectifier;Vishay Silicon;B4S;;2; 1-Channel Photocoupler;LiteOn;LTV-816;;1; 4.1A 150V N-Channel MOSFET;ON Semiconductor;FDS86242;;1; 60V N-Channel MOSFET;Vishay Siliconix;Si4850EY;;2;
Other
Manuf/OEM/ODM	Senao
3rd Party Firmware Support	OpenWrt • (List | Dev | DLs)
Retail
Availability	End of Life
End of Life date	2017
FCC approval date	11 December 2013
ASINs	B00ISCJ1IE B00KK93Q5C
Country of manuf	Taiwan
Radio 1
Chip1	Qualcomm Atheros QCA9557
Wireless interface OUI	00:18:0A
Antenna Connector Type	U.FL
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/b/g/n
802.11n	up to 300/300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	Atheros AR9582
Wireless interface OUI	00:18:0A
Antenna Connector Type	U.FL
MIMO status	2x2:2
Wireless Standard	IEEE 802.11a/n
802.11n	up to 300 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz
Radio 3
Chip1	Atheros AR9582
Wireless interface OUI	00:18:0A
Antenna Connector Type	U.FL
MIMO status	2x2:2
Wireless Standard	IEEE 802.11b/g/n
802.11n	up to 300 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Qualcomm Atheros (QCA) chipsets with specifications, see Qualcomm Atheros.

For a list of all currently documented Cisco devices with specifications, see Cisco.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.),

• 300 Mbps - 2SS 5GHz 802.11n (40MHz chan.) = AN600 class

Overview

This is a three radio device (11b/g/n, 11a/n, 11a/b/g/n [Air Marshall?]).

It would appear to be using Atheros silicon (AR9344 + AR???? (AR9382 / AR9582?) + AR9374?)Senao CAP4200AG ??

The FCC EUT has a MAC address starting with 00:18:0A. It's presumed to be used.

Links of Interest

• https://meraki.cisco.com/lib/pdf/meraki_datasheet_MR18.pdf

Flashing

Flashing OpenWrt

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki
On the OpenWrt Forum

Target: ath79
Subtarget: nand
Package architecture: mips_24kc
Supported Since Commit
Support started version: 17.01.0
Current supported version: 24.10.5

LAN Comment: PoE
WLAN Hardware: Qualcomm Atheros QCA9557, Atheros AR9582 x2
Installation method(s):
see devicepage

Hardware
Architecture: MIPS
Vendor: Atheros/Qualcomm
System-On-Chip: Atheros/Qualcomm QCA9557-AT4A
CPU Speed: 720MHz
Flash size: SK hynix 128MiB NAND
RAM: 2x Unknown DDR2 64MiB
Wireless: SoC AR9550 + 2x Atheros AR9582-AR1A
Switch: None
Ethernet port: 1x Gigabit AR8035-A, 802.3af PoE capable
USB: No
Serial: Yes, 115200 8N1, left to right: VCC/RX/TX/GND
JTAG: Yes, EJTAG 1.2
Bootloader: nandloader (Cisco made)

git • >>
ar71xx: add support for Cisco's MR18 This patch adds support for Cisco's MR18. Detailed instructions for the flashing the device can be found in the OpenWrt forum thread: <https://forum.openwrt.org/viewtopic.php?id=59248>

Pictures

User Images

• 
  Board Top
• 
  Board Bottom