Rakwireless RAK633

From TechInfoDepot
Jump to navigationJump to search
bgn (N300)
Single Board Computer
3rd Party Firmware
dd-wrt Status Unknown
OpenWrt Supported
Tomato any flavor Incompatible
Gargoyle Status Unknown
Platform
Brand • Model • Rev Rakwireless RAK633
FCC ID none specified
Type single-board computer
CPU1 checkY MediaTek MT7628AN
CPU1 Type MIPS 24KEc
CPU1 Speed 580 MHz
Flash1 Chip Brand? Model?
Flash1 Size 8 MiB 8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br />
RAM1 Size 64 MiB 67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br />
RAM1 Chip Brand? Model?
ETH chip1 MediaTek MT7628AN
Switch MediaTek MT7628AN
Ethernet Port Count 1-100MbE-WAN
4-100MbE-LAN
Wired Standard IEEE 802.3i/3u

802dot11 OUI: none specified

Stock bootloader U-Boot
Expansion IF types USB 2.0
USB ports 1
USB Hub Compatible Untested
Power 3.3 VDC, 0.8 A
Serial Port (UART) yes
JTAG Port no
Other
3rd Party Firmware Support OpenWrt • (List | Dev | DLs)
Radio 1
Chip1 MediaTek MT7628AN
Wireless interface OUI none specified
Antenna Connector Type none specified
MIMO status 2x2:2
Wireless Standard IEEE 802.11b/g/n
802.11n up to 300 Mbps
802.11g up to 54 Mbps
802.11b up to 11 Mbps
WiFi Operating Frequency 2.4 GHz

For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

• 300 Mbps - 2SS 2.4GHz 802.11n (40MHz chan.) = N300 class

Flashing

Flashing OpenWrt

Target: ramips
Subtarget: mt76x8
Package architecture: mipsel_24kc
Supported Since Commit
Support started version: 19.07.0
Current supported version: 25.12.2
LAN Comment: Ports via 'motherboard', this is a SBC module
WLAN Hardware: MediaTek MT7628AN
Installation method(s):
U-Boot TFTP + serial recovery, see git-commit
Recovery method(s):
U-Boot TFTP + serial recovery
Comment:
Outdoor use requires additional outdoor rated enclosure
git • >>
ramips: add support for Rakwireless RAK633
It's OEM module with 2*26 pin header, similar to LinkIt Smart 7688 or
Vocore2.

Specification:

CPU:       MT7628 580 MHz. MIPS 24K
RAM:       64 MB
Flash:     8 MB
WIFI:      802.11n/g/b 20/40 MHz
USB:       1x Port USB 2.0
Ethernet:  5 Port ethernet switch
UART:      2x

Installation: Use the installed uboot Bootloader. Connect a serial cable
to serialport 0. Turn power on.  Choose the option: "Load system code
then write to Flash via TFTP".  Choose the local device IP and the TFTP
server IP and the file name of the system image.  After if the
Bootloader will copy the image to the local flash.

Notes: The I2C Kernel module work not correctly. You can send and
receive data. But the command i2cdetect doesn’t work. FS#845