Sagemcom F@ST 3864OP
From TechInfoDepot
Jump to navigationJump to search
| bgn (N450) | |
|---|---|
| Optus | |
 | |
| 3rd Party Firmware | |
| dd-wrt | Status Unknown |
| OpenWrt | Partial Support |
| Tomato any flavor | Status Unknown |
| Gargoyle | Status Unknown |
| Platform | |
| Brand • Model • Rev | Sagemcom F@ST 3864OP |
| FCC ID | none specified |
| Type | wireless router, dsl modem |
CPU1  | Broadcom BCM63168 |
| CPU1 Type | BMIPS4350 |
| CPU1 Speed | 400 MHz ( 2 cores ) |
| Flash1 Chip | Winbond W29N01HVSINA |
| Flash1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (NAND) |
| RAM1 Size | 128 MiB 134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (DDR3) |
| RAM1 Chip | Nanya NT5CC64M16GP-DI |
| ETH chip1 | Broadcom BCM63168 |
| Switch | Broadcom BCM53124 |
| Ethernet Port Count |
1-1GbE-WAN 4-1GbE-LAN |
| Wired Standard | IEEE 802.3i/3u/3ab |
|
802dot11 OUI: none specified | |
| Stock bootloader | CFE |
| Expansion IF types | USB 2.0 |
| USB ports | 2 |
| USB Hub Compatible | Untested |
| Power | 12 VDC, 2.5 A |
| Serial Port (UART) | yes, 3.3V TTL, (115200 8N1) |
| JTAG Port | no |
|
Flags: | |
|
| |
| Other | |
|
| |
| 3rd Party Firmware Support |
OpenWrt • (List | Dev | DLs) |
| Radio 2 | |
| Chip1 | Brand? Model? |
| Wireless interface OUI | none specified |
| Antenna Connector Type | none specified |
| MIMO status | 3x3:3 |
| Wireless Standard | IEEE 802.11b/g/n |
| 802.11n | up to 450 Mbps |
| 802.11g | up to 54 Mbps |
| 802.11b | up to 11 Mbps |
| WiFi Operating Frequency | 2.4 GHz |
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
For a list of all currently documented Sagemcom devices with specifications, see Sagemcom.
- • 450 Mbps - 3SS 2.4GHz 802.11n (40MHz chan.) = N450 class
Flashing
 | NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
 | DSL will not work at all on devices with BCM63xx DSL chipset (due to unavailability of FLOSS driver for Broadcom chips). Consider this when choosing a device to buy, or when deciding to flash OpenWrt on your device because it is listed as supported. See Broadcom DSL, Unsupported: DSL modem and Broadcom BCM63xx for details. |
Target: bmips
Subtarget: bcm63268
Package architecture: mips_mips32
Supported Since Commit
Support started version: 24.10.0
Current supported version: 25.12.0
Subtarget: bcm63268
Package architecture: mips_mips32
Supported Since Commit
Support started version: 24.10.0
Current supported version: 25.12.0
Unsupported Functions:
WiFi 2.4GHz, Wifi 5G, FXS, xDSL, gpio-leds
WLAN Comment: Broadcom BCM53124SKMMLG
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
WiFi 2.4GHz, Wifi 5G, FXS, xDSL, gpio-leds
WLAN Comment: Broadcom BCM53124SKMMLG
Installation method(s):
see git-commit
Recovery method(s):
see git-commit
| git • >> |
|---|
bmips: add support for Sagem F@ST3864OP Specifications: * SoC: BCM63168 * RAM: NT5CC64M16GP-DI, DDR3 128MiB * NAND: W29N01HVSINA, 128MiB * Ethernet: 4x1000M LAN, 1x 1000M WAN * Serial interface: on board but not populated, 3.3V, 115200, 8N1 Notes: * Use DSA for VLAN and switches * Ethernet ports and USB works * gpio-leds are not working * WLAN, xDSL, and FXS are not going to work |
Categories:
- Sagemcom
- Embedded system/wireless router
- Embedded system/dsl modem
- Embedded System Broadcom
- Embedded System BCM63168
- Broadcom
- Embedded System BMIPS4350
- Embedded System
- Embedded System BCM53124
- OpenWrt Supported
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Dual-Radio Wireless Embedded System
- Wireless Embedded System
- Single-Band
- English Documentation
