Tenda BE12 Pro

abgn+ac+ax+be (BE7200)
	BE7200 Dual Band Gigabit Wi-Fi Router
Homepage	Product page
Support	Support page
WikiDevi.wi-cat.ru	Tenda BE12 Pro
3rd Party Firmware
dd-wrt	Supported
OpenWrt	Status Unknown
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Tenda BE12 Pro
FCC ID	none specified
Type	wireless router
CPU1	MediaTek MT7987AV
CPU1 Type	ARM Cortex-A53
CPU1 Speed	2.0 GHz ( 4 cores ) 64-bit
Flash1 Chip	Brand? Model?
Flash1 Size	128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI NAND)
RAM1 Size	512 MiB536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br /> (DDR4)
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7987AV
ETH chip2	EcoNet EN8811H
Switch	Airoha AN8855AE
Ethernet Port Count	2-2.5GbE-WAN; 3-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab/3bz
	802dot11 OUI: none specified;
Stock bootloader	U-Boot
Expansion IF types	none specified
Power	12 VDC, 2 A
Connector type	barrel
Serial Port (UART)	yes, 3.3V TTL, (115200 8N1)
	Flags:; Wi-Fi 7, HE160, WPA3
Other
3rd Party Firmware Support	OpenWrt • (List \| Dev \| DLs);
Retail
(Est.) release date	December 2025
Country of manuf	China
Radio 1
Chip1	MediaTek MT7992E
Chip2	MediaTek MT7975N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x4:4
Wireless Standard	IEEE 802.11b/g/n/ax/be
802.11be	up to 1356 Mbps
ax-QAM	up to 1376 Mbps
802.11ax	up to 1148 Mbps
802.11n	up to 600 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7992E
Chip2	MediaTek MT7979N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x5:4
Wireless Standard	IEEE 802.11a/n/ac/ax/be
802.11be	up to 5765 Mbps
AX-QAM	up to 4804 Mbps
802.11ax	up to 2402 Mbps
802.11ac	up to 1733 Mbps
802.11n	up to 600 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz

For a list of all currently documented Airoha (EcoNet) chipsets with specifications, see Airoha.
For a list of all currently documented EcoNet (MediaTek) SoC's with specifications, see EcoNet (MediaTek).
For a list of all currently documented MediaTek chipsets with specifications, see MediaTek.

For a list of all currently documented Tenda devices with specifications, see Tenda.

• 1376 Mbps - 4SS 2.4GHz 802.11be (40MHz chan.),

• 5765 Mbps - 4SS 5/6GHz 802.11be (160MHz chan.) = BE7200 class

Overview

Links of Interest

Tenda BE12 Pro on AC|WiFi

Flashing

NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power.

Flashing OpenWrt

The development branch can contain experimental code that is under active development and should not be used for production environments. Snapshot images may support additional hardware; however, it is experimental, considered unstable, and sometimes won't compile.

Prebuilt snapshot images do not come with any web interface or GUI. You will need to be comfortable using a command line and remote shell to install one yourself → How to install LuCI

On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki
On the OpenWrt Forum

Target: mediatek
Subtarget: filogic
Package architecture: aarch64_cortex-a53
Supported Since Commit
Support started version: unknown
Current supported version: snapshot

LAN Hardware: Airoha AN8855AE
LAN Comment: Airoha EN8811H 2.5Gbe Phy
WLAN Hardware: MediaTek MT7992E, MediaTek MT7975N, MediaTek MT7979N
WLAN Comment: MIMO: 4x4:4 on both bands
Installation method(s):
see devicepage
Install Comment:
https://www.right.com.cn/forum/thread-8463884-1-1.html
Recovery method(s):
see devicepage
Recovery Comment:
https://www.right.com.cn/forum/thread-8463884-1-1.html
Comment:
Despite the "BE" in the model name, it doesn't actually come with any 6GHz radio

git • >>

mediatek: filogic: add support for Tenda BE12 Pro
This patch adds support for Tenda BE12 Pro.

The stock bootloader requires a specific 16-byte header (Magic: "God1")
to correctly verify and boot the Linux kernel from flash. A new image
command `tenda-mkdualimageheader` is added to generate this header and
append the checksum/size information required for the device to boot
successfully.

Hardware Specification:
- SoC: MediaTek MT7987A (Quad-core ARM Cortex-A53 2.0 GHz)
- RAM: 512 MiB DDR4
- Flash: 128 MiB SPI-NAND
- WiFi: MediaTek MT7992E (WiFi 7)
  - 2.4GHz: b/g/n/ax/be (4x4 MIMO)
  - 5GHz: a/n/ac/ax/be (4x4 MIMO)
- Ethernet:
  - 3x 10/100/1000 Mbps LAN (Airoha AN8855AE Switch)
  - 1x 10/100/1000/2500 Mbps LAN (SoC internal PHY)
  - 1x 10/100/1000/2500 Mbps WAN (Airoha EN8811H PHY)
- Buttons: Reset, WPS
- LEDs: 2x (Blue: System/Run, Red: Alarm)
- UART: 115200 8n1 (VCC, RX, TX, GND)

Flash Layout:
- 0x000000 - 0x300000 : Bootloader
- 0x300000 - 0x380000 : u-boot-env
- 0x380000 - 0x780000 : Factory
- 0x780000 - 0xd80000 : kernel
- 0xd80000 - 0x6780000 : ubi (rootfs)
- 0x6780000 - 0x6b80000 : CFG
- 0x6b80000 - 0x6f80000 : MISC2

MAC Addresses (NVMEM):
- Base MAC located at Factory partition offset 0x4
- gmac2 (WAN) : Base - 2 (Label MAC)
- gmac0 (LAN) : Base - 1
- gmac1 (LAN) : Base - 3
- 2.4 GHz     : Base
- 5 GHz       : Base + 1

Installation:
1. Connect via UART and interrupt U-Boot by pressing 'Ctrl+C' during boot.
2. Set up a TFTP server on a computer (IP 192.168.1.2) containing
   'openwrt-initramfs.bin'.
3. Load the initramfs image:
   tftpboot openwrt-initramfs.bin
4. Boot the image:
   bootm
5. Once booted into OpenWrt initramfs, perform a sysupgrade with the
   sysupgrade image.

Signed-off-by: Chen Minqiang
Link: https://github.com/openwrt/openwrt/pull/21461
Signed-off-by: Hauke Mehrtens

Tenda BE12 Pro

Overview

Links of Interest

Flashing

Flashing OpenWrt

See also

Navigation menu

Page actions

Page actions

Personal tools

empty section

Search

Navigation

data/misc

Tools

query forms

Shoutwiki

ShoutWiki messages

abgn+ac+ax+be (BE7200)
BE7200 Dual Band Gigabit Wi-Fi Router

Homepage	Product page
Support	Support page
WikiDevi.wi-cat.ru	Tenda BE12 Pro
3rd Party Firmware
dd-wrt	Supported
OpenWrt	Status Unknown
Tomato any flavor	Incompatible
Gargoyle	Status Unknown
Platform
Brand • Model • Rev	Tenda BE12 Pro
FCC ID	none specified
Type	wireless router
CPU1 Y	MediaTek MT7987AV
CPU1 Type	ARM Cortex-A53
CPU1 Speed	2.0 GHz ( 4 cores ) 64-bit
Flash1 Chip	Brand? Model?
Flash1 Size	128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (SPI NAND)
RAM1 Size	512 MiB536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br /> (DDR4)
RAM1 Chip	Brand? Model?
ETH chip1	MediaTek MT7987AV
ETH chip2	EcoNet EN8811H
Switch	Airoha AN8855AE
Ethernet Port Count	2-2.5GbE-WAN 3-1GbE-LAN
Wired Standard	IEEE 802.3i/3u/3ab/3bz
802dot11 OUI: none specified
Stock bootloader	U-Boot
Expansion IF types	none specified
Power	12 VDC, 2 A
Connector type	barrel
Serial Port (UART)	yes, 3.3V TTL, (115200 8N1)
Flags: Wi-Fi 7, HE160, WPA3

Other

3rd Party Firmware Support	OpenWrt • (List \| Dev \| DLs)
Retail
(Est.) release date	December 2025
Country of manuf	China
Radio 1
Chip1	MediaTek MT7992E
Chip2	MediaTek MT7975N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x4:4
Wireless Standard	IEEE 802.11b/g/n/ax/be
802.11be	up to 1356 Mbps
ax-QAM	up to 1376 Mbps
802.11ax	up to 1148 Mbps
802.11n	up to 600 Mbps
802.11g	up to 54 Mbps
802.11b	up to 11 Mbps
WiFi Operating Frequency	2.4 GHz
Radio 2
Chip1	MediaTek MT7992E
Chip2	MediaTek MT7979N
Wireless interface OUI	none specified
Antenna Connector Type	none specified
MIMO status	4x5:4
Wireless Standard	IEEE 802.11a/n/ac/ax/be
802.11be	up to 5765 Mbps
AX-QAM	up to 4804 Mbps
802.11ax	up to 2402 Mbps
802.11ac	up to 1733 Mbps
802.11n	up to 600 Mbps
802.11a	up to 54 Mbps
WiFi Operating Frequency	5 GHz