UDOO Quad

From TechInfoDepot
Jump to navigationJump to search
bgn (N150)
Single-board Computer w/Arduino Interface
Homepage
3rd Party Firmware
dd-wrt
Status Unknown
OpenWrt
Status Unknown
Tomato any flavor
Incompatible
Gargoyle
Status Unknown
Platform
BrandModelRev
UDOO Quad
FCC ID
IC ID
Type
single-board computer
CPU1
Freescale (NXP) i.MX6Q
CPU1 Type
ARM Cortex-A9
CPU1 Speed
not specified ( 4 cores )
CPU2
Atmel SAM3X8E
Flash1 Chip
Brand? Model?
Flash1 Size
0 MiB0 B <br />0 Kib <br />0 KiB <br />0 Mib <br />0 GiB <br />
RAM1 Size
1 GiB 1,024 MiB <br />1,073,741,824 B <br />8,388,608 Kib <br />1,048,576 KiB <br />8,192 Mib <br />
RAM1 Chip
Micron MT41K128M16JT-125 x 4
ETH chip1
Freescale (NXP) i.MX6Q
ETH chip2
Micrel KSZ9031RN
Ethernet Port Count
1-1GbE-LAN
Wired Standard
IEEE 802.3i/3u/3ab

802dot11 OUI: 7C:DD:90 (-, 6 W)
Ethernet OUI: 00:C0:08

Stock bootloader
U-Boot 2009.08
Stock FW OS
Linux 3.0.35 Ubuntu 12.04
Expansion IF types
USB 2.0, SATA
USB ports
3
SATA Ports
1
USB Hub Compatible
Untested
Power
6-15 VDC, 2 A
Connector type
barrel
5.5 mm (OD)
2.1 mm (ID)
Serial Port (UART)
yes, USB Female Micro-B, (115200 8N1), CN6
Flags:
HDMI, LVDS, CSI, GPIO, Audio In/Out (3.5mm), Micro SD Card slot

Additional chips
AC’97 Audio Codec;VIA;VT1613;;1;
4-port USB Hub Controller;SMSC;USB2514B;;1;
Single-Chip USB to UART Bridge;Silicon Labs;CP2104;;1;
500mA Low Dropout Regulator;Richtek;RT9186A;;1;
4A, 21V 500kHz Synchronous Step-Down Converter;Richtek;RT8287A;;4;
High-Speed USB 2.0 DPDT Switch;AlphaΩAOZ6184;;1;
DDR Termination Regulator;Richtek;RT9040;;1;
4-Pin Microprocessor Power Supply Supervisor;On Semiconductor;CAT811;;1;
8-bit Flash Microcontroller;Microchip;PIC10F200;;1;
Quadruple FET Bus Switch;Texas Instruments;CBT3125PW;;1;
Dual 2A, 1.2V Rate Controlled Load Switch, Vishay Siliconix;SiP32416;;1;
2A, 1.2V Rate Controlled Load Switch, Vishay Siliconix;SiP32411;;1;
Processor Supervisory Circuit;Diodes Inc;APX823;;1;
D-Type CMOS Flip-Flop;ON Semi;NC7SZ74K8X;;1;
Single Buffer Driver w/Open-Drain Output;TI;SN74LVC1G07;;1;
ESD Protection Diode for HDMI;NXP;IP4283CZ10;;2;

Other

Default IP address: acquired via DHCP
the IP acquired via DHCP is used by 211 additional devices
of which 1 are UDOO devices
Default login user: root
Default login password: ubuntu

Manuf/OEM/ODM
SECO CS975 REV D
3rd Party Firmware Support
Arch Linux ARM • (List | DLs)
, Armbian, Debian
, Android 4.4, Android 6.0
Retail
FCC approval date 09 November 2012
(Est.) release date September 2013
(Est.) initial retail price (in USD): $169
Radio 1
Radio1 module
Radio1 module IF
USB
Chip1
Ralink RT5370
Wireless interface OUI
7C:DD:90
Antenna Connector Type
PCB on-board
MIMO status
1x1:1
Wireless Standard
IEEE 802.11b/g/n
802.11n
up to 150 Mbps
802.11g
up to 54 Mbps
802.11b
up to 11 Mbps
WiFi Operating Frequency
2.4 GHz
 FCC ID
ECHIP GWF-3M08QR4WF5370M08
UDOO DualQR4WF5370M08

For a list of all currently documented Atmel chipsets with specifications, see Atmel.
For a list of all currently documented Freescale (NXP) SoC's with specifications, see Freescale.
For a list of all currently documented Micrel (Kendin) chipsets with specifications, see Micrel.
For a list of all currently documented Ralink chipsets with specifications, see Ralink.

For a list of all currently documented UDOO device with specifications, see UDOO.

150 Mbps - 1SS 2.4GHz 802.11n (40MHz chan.) = N150 class

Overview

Hardware specification

  • CPU: Freescale i.MX6Q Quad-core Cortex-A9
  • GPU: Vivante GC 2000 + Vivante GC 320 + Vivante GC 355
  • MCU: Atmel SAM3X8E Cortex-M3
  • Memory: 1GB (SDRAM) DDR3
  • Onboard Storage: TF card (max. 64GB) / MMC Card Slot, SATA

Links of Interest